Delta SA446 Instruction Manual

Download Instruction manual of Delta SA446 Sander for Free or View it Online on All-Guides.com.

Brand: Delta

Category: Sander

Type: Instruction manual for Delta SA446

Pages: 23 (0.85 Mb)

Download Delta SA446 Instruction manual

Delta SA446 Instruction manual - Page 1
1
Delta SA446 Instruction manual - Page 2
2
Delta SA446 Instruction manual - Page 3
3
Delta SA446 Instruction manual - Page 4
4
Delta SA446 Instruction manual - Page 5
5
Delta SA446 Instruction manual - Page 6
6
Delta SA446 Instruction manual - Page 7
7
Delta SA446 Instruction manual - Page 8
8
Delta SA446 Instruction manual - Page 9
9
Delta SA446 Instruction manual - Page 10
10
Delta SA446 Instruction manual - Page 11
11
Delta SA446 Instruction manual - Page 12
12
Delta SA446 Instruction manual - Page 13
13
Delta SA446 Instruction manual - Page 14
14
Delta SA446 Instruction manual - Page 15
15
Delta SA446 Instruction manual - Page 16
16
Delta SA446 Instruction manual - Page 17
17
Delta SA446 Instruction manual - Page 18
18
Delta SA446 Instruction manual - Page 19
19
Delta SA446 Instruction manual - Page 20
20
Delta SA446 Instruction manual - Page 21
21
Delta SA446 Instruction manual - Page 22
22
Delta SA446 Instruction manual - Page 23
23
19
MACHINE USE
SURFACING OR EDGE SANDING WITH THE SANDING BELT
Always use the backstop (A) Figs. 39 and 40 when surface-sanding (Fig. 39) or when edge sanding Fig. 40. Hold the
workpiece firmly and keep your fingers away from the sanding belt. Keep the end of the workpiece against the backstop
and move the workpiece evenly across the sanding belt. Apply only enough pressure to allow the sanding belt to
remove material. Use extra caution when sanding very thin pieces.
Fig. 39
Fig. 40
A
A
To avoid trapping the work or fingers between the backstop and the sanding belt, the edge of the
table should be positioned a maximum of 1/16" away from the sanding belt .
Sanding inside curves with the sanding belt is illustrated in Fig. 41.
Sanding outside curves with the sanding disc is illustrated in Fig. 42.
SANDING INSIDE AND OUTSIDE CURVES
Fig. 42
Fig. 41
Always sand on the left (downward) side of the sanding disc (Fig. 41). Sanding on the right
(upward) side of the sanding disc could cause the workpiece to fly up suddenly which could be
hazardous.
To avoid trapping the work or fingers between the backstop and the abrasive, the edge of the
table should be positioned a maximum of 1/16" away from the abrasive .