• Home
• Brands
• Airlinkplus Manuals
• Airlinkplus AKVM-4
• Airlink AKVM-4 Quick Installation Manual

Airlink AKVM-4 Quick Installation Manual

Download Quick installation manual of Airlinkplus AKVM-4 Switch for Free or View it Online on All-Guides.com.

1

2

Ver. 1A

Quick Installation Guide

1

Model # AKVM-4

Section 1

The AKVM-4 switch is a 4-port PS/2 type KVM switch

that comes with 3-in-1 combo KVM cables to save you

cabling troubles. It enables users to access, control,

boot, and reboot up to 4 computers using only one key-

board, video monitor, and mouse. It can be your best

companion for managing 2 to 4 computers on either

SOHO or corporate desktop.

Introduction

Section 2

Before connecting any cable, please make sure all of your

computers and their peripherals have been powered off.

Otherwise, the KVM switch may not be set up properly.

Installation

Step 1 Make sure all the computers that are to be

connected to the KVM switch and their peripherals

are powered-off. If not, power them off before you

proceed with the following steps.

Step 2 Connect the shared keyboard, monitor, and

mouse to the main KVM unit. See Fig. 1.1

Fig 1.1

Step 3 Connect each of your computer to the KVM

switch using the provided 3-in-1 combo KVM

cables.See Fig. 1.2

Step 4 Power up the connected computers one by

one. After the computers are powered up, the

keyboard and mouse will be recognized and you can

begin operating the KVM switch.

Section 3

Operations

There are two methods to select a specific computer:

Using the push button or the hotkey sequence.

Hotkey Sequence

The hotkey sequence consists of three specific

keystrokes pressd on the keyboard.

Hotkey sequence = ScrLk + ScrLk + Command key

The two consecutive ScrLk key should be pressed

within 2 seconds and the following command key(s)

should also be pressed within 2 seconds. Otherwise,

the hotkey sequence will not be validated.

For detailed Hotkey sequences and their correspond-

ing functions, please refer to the Quick Reference

Chart on back.

Push Button

The push button lets you directly switch between the

computers. Simply press the applicable button on the

KVM unit to select the corresponding computer.

Section 4

Technical Support

Email: [email protected]

Website: www.airlinkplus.com

Continue on Back

PC sideKVM side

Fig 1.2

You can use individual standard keyboard, mouse

and video cables to extend the cable distance, but

depending on the type of cables you use, the

maximum cable distance is limited to 5 ~ 7 meters

(15.5 ~ 23 feet).