XTANT 2140C Manual

Download Specifications of Xtant 2140C Amplifier for Free or View it Online on All-Guides.com.

Brand: Xtant

Category: Amplifier

Type: Specifications for Xtant 2140C

Pages: 1 (0.18 Mb)

Download Xtant 2140C Specifications

Xtant 2140C Specifications - Page 1
1
3 o v.2.00
2140c specifications
Watts Per Channel @ 4 2 x 70
Watts Per Channel @ 2 2 x 140
Watts Per Channel @ 4 Bridged 1 x 280
Frequency Response: 5 Hz to 50 kHz +/– 1 dB
Distortion (THD): < .04%
Signal to Noise Ratio: > 100 dB
Damping Factor: > 200 @ 100 Hz with 4 load
Input Sensitivity (unbalanced source): 100 mV to 8.5 V RMS
Input Sensitivity (balanced source): 100 mV to 17 V RMS
Input to Line Output Gain: 0 dB +/– 20 dB, 10 dB steps
Operational Voltage: 11 to 15 Volts
On-Board Crossover: 12 dB per Octave “Butterworth”
Module Port(s): 1 – Accessory Port
1 – Balanced Line Port
Power Supply: Fully Regulated, PWM
Fusing: 50 Amp
2140c features
DISCONTINUED DECEmBER 1997
Fully regulated, PWM power supply.
Doubling of power from 4 to 2 loads.
Hand-matched, complementary MOSFETS
for better performance and sound quality.
Fully discrete power amp.
• Independent amplifier channel gain adjust-
ment.
Forced air convection cooling.
Over-current and thermal protection circuitry.
Input sensitivity (100 mV to 8 V RMS)
adjustable in 10 dB steps.
Balanced line input ports – designed to
accept our (optional) BLM 1 module.
One accessory port – designed to accept our
(optional) accessory modules.
Built-in noise gate with threshold adjust-
ment control.
13 frequencies available for each amplifier.
RCA line level outputs controlled by on-
board crossovers.
On-board crossover has 3 modes of opera-
tion – high pass, low pass, or bypass.
Amp may be run in “Mixed Mono” mode
using passive crossovers.
4 year parts and labor warranty when
installed by an authorized Xtant dealer.