• Home
• Brands
• Eagle Tree Systems Manuals
• Eagle Tree Systems Computer Monitor
• Eagle Tree Systems Computer Monitor User Manual

Eagle Tree Systems Computer Monitor User Manual

Download Operation & user’s manual of Eagle Tree Systems Computer Monitor Monitor for Free or View it Online on All-Guides.com.

1

2

3

4

Copyright © 2006 Eagle Tree Systems, LLC

User Manual for the PowerPanel LCD Display Expander

Document Version 1.7

Thank you for your purchase of the PowerPanel - a tiny, lightweight Watt Meter for your model! This instruction manual will guide

you through the installation and operation of your PowerPanel LCD Display. Please read the entire manual carefully before

proceeding. If, after you read the manual (including the Troubleshooting sections!) you have further questions or problems, see the

Support page on http://www.eagletreesystems.com for additional information, or email us at support@eagletreesystems.com.

Key Features

Here are a few of the features of the PowerPanel:

• Ultra-thin LCD display connects to the MicroPower with the included 11" (28cm) data cable.

• Live Display of Amps, Volts, mAH, Temperatures, Wattage, and RPM (more coming soon, by simply download our latest

Windows program).

• Cumulative mAH display serves as a “gas gauge” for your battery pack. By knowing how much has been used, you can know

approximately how much is left!

• Up to 4 parameters can be displayed per “virtual page” on the PowerPanel. Each parameter has a programmable label.

• Multiple “virtual pages” of data are supported, with programmable ways of switching between the pages.

• Supports display of both Live data and Max values, with programmable ways of switching between Live and Max.

• Supports “hot plugging” into the MicroPower after your session.

• So light, it can easily be attached to the side of your model for live/max display all the time!

• System supports both Metric and English units.

Supported Products

The PowerPanel works with the eLogger V1 through V3. To use the PowerPanel with the eLogger, you must update to Windows

Application version 3.64 or higher. This is described in the “Windows Application and Firmware Update” section below.

Steps to Follow

Installation and use of your PowerPanel will be quite easy and enjoyable if you follow these few steps:

1. Read through the manual to understand the warnings, determine the installation and setup sequence, etc.

2. Upgrade the Windows Application and Firmware for your MicroPower, if you purchased your MicroPower before the PowerPanel

was available. This is described in the “Windows Application and Firmware Update” section below.

3. Connect the PowerPanel to the MicroPower. You should now see live data on the PowerPanel!

4. If desired, reconfigure the parameters displayed on the PowerPanel as described in the “Configuring the PowerPanel with the

Application” section below.

5. Have fun!

Intended Uses

The PowerPanel is designed for use in Unmanned Radio Controlled models. Using the PowerPanel for other purposes is not supported.

Further, using the PowerPanel in situations where its use or failure could result in loss of life, bodily injury or property damage is

expressly prohibited.

Packing List

Your package should include the following: the PowerPanel LCD Expander, and a printed version of this manual. Please check the

support page of our website for the latest version of this manual, in case changes have been made since it was printed.

NOTE: the PowerPanel is covered with protective clear shrinkwrap. Do not remove the shrinkwrap!

Windows Application and Firmware Update

To use the PowerPanel with the MicroPower, you must update to Windows Application version 3.64 or higher. To update, download the latest

application from the support page of our website.

After downloading and installing the Application, the firmware of your MicroPower may need to be updated. Firmware version 4.45 or greater is

required for the PowerPanel to work correctly. To upgrade your MicroPower firmware, choose “Tools, Firmware Control” and click the Update

button.