Echo 99944200545 Operator's Manual

Download Operator's manual of Echo PRO ATTACHMENT SERIES PAS-230 Trimmer for Free or View it Online on All-Guides.com.

Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 1
1
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 2
2
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 3
3
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 4
4
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 5
5
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 6
6
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 7
7
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 8
8
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 9
9
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 10
10
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 11
11
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 12
12
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 13
13
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 14
14
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 15
15
Echo PRO ATTACHMENT SERIES PAS-230 Operator's manual - Page 16
16
TRIMMER ATTACHMENT
OPERATOR'S MANUAL
13
D
C
E
CC
FF
B
3. Use one piece of new nylon line (C) 6 m (20 ft.) long and thread
through the molded loop (D) on the spool. Pull line tight and
adjust so one end is 15 cm (6 in.) longer than the other.
4. Hold the spool, opening toward you. Place index finger between
the two strands and wind line, tightly and evenly, in direction of
arrow (E) marked "CC".
5. Stop when approximately 15-20 cm (6-8 in.) line (C) remains and
place ends of line in notches (F) in spool (B).
6. Feed ends of line through housing eyelets (G) and place spool (B)
over drive (H). Align pegs (I) on drive with notches in spool, and
push spool into drum.
7. Pull on both lines until they come free from notches (F) in spool.
8. Hold drum (A) firmly and turn spool (B) CCW (counterclockwise)
until it stops. DO NOT push in on spool when turning.
9. Pull both lines out and trim to cut-off knife length.
I
G
G
B
H
B
A