Edelbrock 15010 Installation Instructions
Download Installation instructions of Edelbrock 15010 Automobile Parts for Free or View it Online on All-Guides.com.
Brand: Edelbrock
Category: Automobile Parts
Type: Installation instructions for Edelbrock 15010
Pages: 1 (0.05 Mb)
1
Catalog #15010
Rev. 11/06 - RS/mc
©2006 Edelbrock Corporation
Brochure #63-0250
OIL SUPPLY ADAPTER
For Honda/Acura B-Series and D-Series Engines
Catalog #15010
INSTALLATION INSTRUCTIONS
®
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and
procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing this installation,
it is recommended to have the installation completed by a qualified mechanic. If you have any questions, please call our Technical Hotline at:
1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday or e-mail us at [email protected].
IMPORTANT NOTE: Proper installation is the responsibility of the installer. Improper installation
will void your warranty and may result in poor performance and engine or vehicle damage.
DESCRIPTION: Designed for Honda/Acura B-Series and D-Series engines equipped with or without a factory water-cooled oil cooler, this kit can
supply oil for a VTEC conversion or for a turbocharger. The adapter also includes a port for an oil pressure gauge. The adapter fits directly between
the engine block, or factory oil cooler, and the stock oil filter.
KIT CONTENTS:
❑ 1 Oil Supply Sandwich Adapter Assembly
INSTALLATION PROCEDURE
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
-6AN Fitting
Towards Engine Block
Tighten Using
1/2” Allen
Wrench
Fig. 1
1. Remove the stock oil filter (replace with a new filter).
2. Install the Oil Supply Sandwich Adapter in place of the stock oil filter.
3. Make sure the O-Ring is facing toward the engine block, and the threaded stud with ½” hex opening is facing out
(See Fig. 1)
.
4. Although it is a tight fit, the aluminum housing and the threaded center stud will turn independently of each other. Start the assembly onto the
engine by hand at first. Then, while holding the outer housing in position, tighten the threaded center with a ½” Allen wrench. Make sure to
position the -6 AN (blue) fitting so that it is facing toward the driver’s side, pointing upward slightly (about the 10 o’clock position)
(See Fig. 1)
.
5. Install a new oil filter.
6. Attach an appropriate supply line for the accessory requiring an oil supply. A supply line can be attached using a -6AN (female) fitting. You may
also attach an oil pressure gauge line to the 1/8 NPT port on the Oil Supply Adapter by removing the 1/8 NPT plug, and installing your gauge
fitting.
1/8 NPT Plug
(Not Visible)