Valcom VIP-812 User's Manual

Download Operation & user’s manual of Valcom VIP-812 Network Accessory for Free or View it Online on All-Guides.com.

Brand: Valcom

Category: Network Accessory

Type: Operation & user’s manual for Valcom VIP-812

Pages: 5 (0.15 Mb)

Download Valcom VIP-812 Operation & user’s manual

Valcom VIP-812 Operation & user’s manual - Page 1
1
Valcom VIP-812 Operation & user’s manual - Page 2
2
Valcom VIP-812 Operation & user’s manual - Page 3
3
Valcom VIP-812 Operation & user’s manual - Page 4
4
Valcom VIP-812 Operation & user’s manual - Page 5
5
1 947996
ISSUE 5
VIP-812
DUAL NETWORKED STATION PORT
INTRODUCTION
The VIP-812 Dual Networked Station Port allows
most loop start terminal devices to be connected
to a managed IP-based LAN/WAN.
SPECIFICATIONS
Access Methods
PBX, FXO Port
POTS telephone set
Features
RJ-45 for network connection
2 RJ-11 telephone connections
4 Relays with Form C contacts
Front panel activity LED
Network activity LEDs
2 RENS
2.5mm jack for external power
Power over Ethernet (PoE) 802.3af
compatible
Dimensions/Weight
1.75 H x 6.75" W x 9.5" D
(4.45cm H x 17.15cm W x 24.13cm D)
Weight: 1.75 lbs. (0.80 kg)
Nominal Specifications
Input Impedance: 600 Ohms
Input Level: -10dBm
Output Impedance: 600 Ohms
Output Level: - 10dBm nominal
Relay Current: 1 AMP @ 24VDC
Nominal Power Requirements
Via rear panel barrel connector:
Voltage: 24VDC
Current: 325mA
Via 802.3af (PoE) Ethernet Switch:
802.3af: Class 3
Environment
Temperature: 0 to +40° C
Humidity: 0 to 85% non-precipitating
Packing List
Qty Item
1 VIP-812
1 VSP Document
2 Mounting Brackets W/ Hardware
4 Rubber Pads
INSTALLATION
NOTE: The telephone system referred to in
this manual is the customer premise
equipment such as an electronic key system,
a PBX or a dedicated single line telephone
sets. The VIP-812 is not intended for direct or
indirect connection to the public telephone
network. When used with a customer premise
telephone system such as a key system or
PBX system, these units are interfaced to the
system via a fully protected page port or
system central office port, which is a fully
protected interface device. Also, the host
system must be configured to disallow central
office trunk conferencing in order to prevent
indirect connection to the public network.