• Home
• Brands
• EdgeStar Manuals
• EdgeStar TWR125SS
• EdgeStar Wine Cooler TWR125SS Owner's Manual

EdgeStar Wine Cooler TWR125SS Owner's Manual

Download Owner's manual of EdgeStar TWR125SS Beverage Dispenser for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

Table of Contents

Table of Contents 1

Thanks and Intro 1

Important Safeguards 2

1. Specifications 3

2. Parts and Features 3

3. Operation 3

4. Troubleshooting 5

5. Limited Warranty 8

Thank you and Intro

Thank you for purchasing this EdgeStar wine cooler. Once you get this unit

set up, it will provide you and your family with years of great service.

If you are reading this owner’s manual, you’ve probably already unpacked the

unit. Note that you should save the packaging in case you need to safely

transport this wine cooler in the future.

In order to assemble this wine cooler, carefully

unpack all parts. The only assembly required is that

of the handle. In order to install the handle, you

need a phillips screwdriver, the handle, and the two

installation screws.

• Open the door of the wine cooler.

• Locate the two screw holes on the inside of

the door (they may be partially obscured by

the door liner gasket.) If the gasket obscures

the screw holes, gently pull that section of the

gasket out of the door.

• Insert the screws into the holes. They should

now poke out of the front of the door.

Note: Your door and

handle may appear

different than pictured

• Line up the holes in the handle with the

screws and give each screw about 2-4 full

turns into the handle.

• Now screw the screws in all the way, reset the gasket into the door (if

you removed it) and your handle is installed!

After you get the handle installed, make sure that your wine cooler is fully

unpacked, and position it where you want it to go (remember, for the best

conditions for your wine, choose a spot in a cool (room temperature) area, out

of the sun, and with about 2-4” around all sides and the back for adequate

ventilation. Make sure the unit is set on a sturdy surface that can support its

weight. Note that you can screw in and out the legs to level the unit. You may

also want to clean the interior with a solution of mild soap and water and a

damp cloth. Then plug the unit in, set the temperature, and fill it with wine.

At what temperature should you set the wine cooler? Some of the experts

differ in their opinions, but we recommend low to mid 50’s (F) for whites and

mid 60’s (F) for reds. Enjoy!

1