• Home
• Brands
• A.O. Smith Manuals
• A.O. Smith BT180-100
• A.O. Smith BT180-100 Specification Sheet

A.O. Smith BT180-100 Specification Sheet

Download Specification sheet of A.O. Smith BT180-100 Water Heater for Free or View it Online on All-Guides.com.

1

illc @Jc ~[illDv~

APPROVAL RATINGS AND CERTIFICATION

All models comply with ANSI Z21.1 0.3 CGA4.3

All models comply with ASHRAE/IES 90.1 b-1992.

C.E.C. California Energy Commission

FEATURES

80% thermal efficiency and standby energy losses approximately

one half of comparable standard atmospheric models

INDUCED DRAFT BUILT-IN BLOWER - Blower comes factory

mounted and wired to the top cover with 6 foot power cord.

Ideal for installations where negative pressure in the building is

present. Blower proves draft prior to ignition. No drafthood or

barometric damper required.

METAL VENTING - Category I appliance, uses standard metal

single wall or "B" type vent. Can be commonly vented with other

Category I appliances. Vent connects directly to the blower outlet.

JACKET - Heavy gauge steel with baked enamel finish over a

bonderized undercoat.

FOAM INSULATION - saves fuel, helps reduce standby heat

loss.

GLASS LINED TANK - Glass specifically developed by A.a.

Smith for water heaters, is permanently fused to steel, providing

years of corrosion protection and dependable use.

HONEYWELL SMARTV ALVETM - Integrated control module and

gas valve, this control monitors all critical water heater functions

including temperature (up to 180°F, 82.2°C) main valve operation,

blower operation, energy cut-out, and hot surface igniter. The

diagnostic LED enables a technician to quickly and easily

service the system and verify safe and efficient operation.

ANODE - CoreGuard long-life, stainless steel core anode rods.

BURNER - Heavy duty cast iron burner. Available in both natural

and propane gas.

FULLY TESTED FOR SAFETY AND PERFORMANCE - Design

classified by Underwriters Laboratory for 180°F hot water service.

Meets rigid requirements of the National Sanitation Foundation

when equipped with the optional leg kit. Certified for use on

combustible flooring.

c

EASY INSTAllATION - All components are factory assembled

and 100% tested prior to shipment. Only gas, water, electrical

and venting connections need to be made. No major field

adjustments are required for proper operation. Includes T&P valve

and drain valve.

Limited Warranty

If the tank should leak any time during the first three years, under

the terms of the limited warranty, A. O. Smith will furnish a

replacement heater; installation, labor, handling and local delivery

extra. THIS OUTLINE IS NOT A WARRANTY. For complete

information, consult the written warranty or A. O. Smith Water

Products Company.

EASY CLEANING - Hand hole cleanout allows easy cleaning.

Warranty does not apply to product installed outside of the United

States of America or its territorial possessions and Canada.

OPTIONAL LEG KIT - Meets NSF Standard 5 with leg kit

#6280-4 BTI 80 & 1 00

A 104.9

July 2000

INDUCED DRAFT COMMERCIAL GAS TANK-

TYPE

WATER HEATERS BT180-100