Viking VCFW750 Installation Instructions Manual
Download Installation instructions manual of Viking VCFW1000 Dishwasher, Garbage Disposal for Free or View it Online on All-Guides.com.
Brand: Viking
Category: Dishwasher , Garbage Disposal
Type: Installation instructions manual
Model: Viking VCFW1000 , Viking VCFW750
Pages: 8 (0.33 Mb)
1
2
3
4
5
6
7
8
1
INSTALLATION/USE INSTRUCTIONS
FOOD WASTE DISPOSER
VIKING RANGE CORPORATION
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
TOOLS AND MATERIALS YOU WILL NEED:
Slotted Screwdriver, Adjustable Pliers, Plumber’s compound, Electrical Tape
TOOLS AND MATERIALS YOU MAY NEED:
Phillips Screwdriver, Drain Auger, Hammer, Hacksaw, Pipe Wrench, 3/8 inch Electrical Clamp Connector,
Wire Nuts (2), Second 1 1/2 inch Drain Trap, , Water Hose Clamp, Copper Ground Wire, Dishwasher
Drain Connection Kit, Air Gap, Electrical On/Off Switch, Drain Tube Extension
RReeaadd tthhrroouugghh tthhee ccoommpplleettee iinnssttrruuccttiioonnss bbeeffoorree iinnssttaalllliinngg tthhee ddiissppoosseerr.. DDeetteerrmmiinnee wwhhiicchh ooff t
thhee ttoooollss aanndd mmaatteerriiaallss yyoouu wwiillll nneeeedd
bbeeffoorree yyoouu bbeeggiinn.. MMaakkee ssuurree yyoouu hhaavvee aallll nneecceessssaarryy ddiissppoosseerr ppaar
rttss bbeeffoorree iinnssttaalllliinngg tthhee ddiissppoosseerr ((sseeee ppaarrtt iiddeennttiiffiiccaattiioonn ddiiaaggrraamm
bbeellooww))..
SAFETY SYMBOLS
INSTALLATION INSTRUCTIONS
CHECK INSTALLATION DIMENSIONS
11
CAUTION
Caution indicates a potentially hazardous situation which,
if not avoided, may result in minor or moderate injury.
WARNING
Warning indicates a potentially hazardous situation
which, if not avoided, could result in death or serious
injury.
A: Disposer height
B: Distance from bottom of sink bowl to centerline of discharge
outlet. (Add 1/2 inch[1.3cm] when stainless steel sink is used.)
C: Distance from centerline of the discharge outlet to end of
discharge tube.
D: Disposer width
E: Distance from disposer vertical centerline to centerline of P-trap
connection.
F: Centerline of disposer discharge to centerline at waste pipe
entering wall. (Dimension “F” must be greater than 1/4 inch [0.6
cm] to prevent standing water in disposer.)
DDiimmeennssiioonn AA BB CC DD EE
1133 1111//1166”” 66 1133//1166”” 44”” 1100 11//1166”” 55 33//44””
((3344..88 ccmm)) ((1177..33 ccmm)) ((1100..22 ccmm)) ((2255..66 ccmm)) ((1144..66 ccmm))
If replacing an existing disposer, skip ahead to Instruction 6. If
this is a first time installation, continue with
IInnssttrruuccttiioonn 22..
MMoouunnttiinngg AAsssseemmbbllyy
A. Cover/Stopper
B. Sink Flange
C. Rubber Gaskets (2)
D. Pressure Plate
E. Upper Mounting Ring
F. Screws (3)
G. Snap Ring
DDiissppoosseerr
H. Mounting Gasket/
Splash Baffle
I. Lower Mounting Ring
J. Dishwasher Inlet
K. Discharge Outlet
L. Wrenchette
DDiisscchhaarrggee
N. Bolt
O. Discharge Tube
(1 1/2” [3.8 cm] Diameter)
P. Flange
Q. Gasket
DISCONNECT SINK DRAIN
22
1. Loosen nut (A) at top of “P-trap" with pipe wrench (see Figure 2-1).
2. Loosen nut (B) at top of extension pipe. Remove extension pipe.
3. Loosen nut (C) at base of sink flange. (If nut is corroded or too tight,
apply penetrating lubricant.)
4. Push sink flange up through sink hole and remove it (see Figure 2-2).
5. Clean sink flange area of any putty or other material.
H
I
J
K
A
B
C
F
D
E