Whirlpool EV188NYW Product Dimensions
Download Product dimensions of Whirlpool EV188NYWQ Freezer, Refrigerator for Free or View it Online on All-Guides.com. This version of Whirlpool EV188NYWQ Manual compatible with such list of devices, as: EV188NYWQ, EV188NYWS, EV188NYW, EV188NYWS - FORCED FAN SIDEKICK WP FRZR
Brand: Whirlpool
Category: Freezer , Refrigerator
Type: Product dimensions
Model: Whirlpool EV188NYWQ , Whirlpool EV188NYWS , Whirlpool EV188NYW , Whirlpool EV188NYWS - FORCED FAN SIDEKICK WP FRZR
Pages: 1 (0.08 Mb)
1
Upright Freezer
PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS
LOCATION REQUIREMENTS
EV188NYW
Electrical: A 115-volt, 60-Hz, AC-only, 15-
or 20-amp fused, grounded electrical supply
is required. It is recommended that a
separate circuit serving only your refrigerator
be provided. Use an outlet that cannot be
turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of
installation, cleaning, or removing a light
bulb, turn the control (Thermostat,
Refrigerator or Freezer Control depending on
the model) to OFF and then disconnect the
refrigerator from the electrical source. When
you are finished, reconnect the refrigerator to
the electrical source and reset the control
(Thermostat, Refrigerator or Freezer Control
depending on the model) to the desired
setting. See “Using the Controls.”
Water: A cold water supply with water
pressure between 30 and 120 psi (207 and
827 kPa) is required to operate ice maker and
water dispenser. If you have questions about
your water pressure, call a licensed, qualified
plumber.
IMPORTANT: The pressure of the water
coming out of a reverse osmosis system
going to the water inlet valve of the
refrigerator needs to be between 30 and
120 psi (207 and 827 kPa).
Reverse Osmosis Water Supply: If a reverse
osmosis water filtration system is connected
to your cold water supply, the water pressure
to the reverse osmosis system needs to be a
minimum of 40 to 60 psi (276 to 414 kPa).
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10326801A
5/17/10
This freezer may be installed side by side with another freezer or refrigerator.
Allow at least 1" (2.54 cm) between back of cabinet and the wall.
If you are installing your freezer next to a fixed wall, leave extra space on the
hinge side to allow for the door to swing open.
Check the strength of the floor before installing your freezer. It should hold the
weight of a freezer fully loaded with food.
NOTE: It is recommended that you do not install the freezer near an oven,
radiator, or other heat source, nor in a location where the temperature will fall
below 55°F (13°C).
Model Size
Height - Overall
“A”
Depth - Without
Handles
“B”
Width - Cabinet
“C”
17.7 cu.ft. 66
5
⁄8" (169.2 cm) 31" (78.7 cm) 30" (76.2 cm)
4
A
overall
C
not incl.
handle
B