Viper Home Quick Start Manual
Download Quick start manual of Viper Home Security System for Free or View it Online on All-Guides.com.
1
2
© 2013 Directed. All rights reserved.
1
Getting Started
Thank you for purchasing the VIPER home monitoring and secu-
rity system starter kit. The VIPER home starter kit includes every-
thing you need to monitor one entry point and detect motion in
one room. The system also has home control expandability. Visit
www.viper.com for additional product and warranty information.
Quick Start Guide
What’s Included What’s Needed
• Computer with internet connection
• Internet access point with RJ-45 port (required for the Cen-
tral Controller connection)
• Tape measure (used when mounting the motion sensor)
• A coin to open the door / window sensors for battery instal-
lation
Note: The 8 digit serial number is located on the bottom of the
Central Controller and inside the battery compartment.
Record serial number here:
1 Central Controller
and Backup Battery
1 Power Adapter
1 Ethernet/LAN Cable
1 Window Decal
3 AA Alkaline Batteries
1 Door/Window Sensor
Set
1 Indoor Motion Sensor
S/N: 000111AE
Serial Number
(2 Locations)
Connecting the Central Controller
Step 1
Step 2
Step 3
Step 4
Other
Install the backup battery fi rst by removing the
Central Controller battery cover to and then reat-
tach once installed.
Step 1
Step 2
Step 3
Step 4
Other
Connect the ethernet/LAN cable to the Central
Controller and your wireless router/modem.
Step 1
Step 2
Step 3
Step 4
Other
Plug the power adapter into the back of the control-
ler and the other end into the home wall outlet.
Step 1
Step 2
Step 3
Step 4
Other
The LED is amber upon turn on and changes to
green once the connection process is complete.
Registration of System and Services
Step 1
Step 2
Step 3
Step 4
Other
After confi rming that the Central Controller displays
a green light. Please visit home.viper.com to begin
the registration process.
Step 1
Step 2
Step 3
Step 4
Other
Enter your 8 digit Central Controller serial number
recorded at that top of this page and click next. If
you receive an error, please confi rm the panel LED is
green.
Step 1
Step 2
Step 3
Step 4
Other
Complete the registration process as shown below.
Keep note of your e-mail, password, and user code.
These are used to log into the smartphone app.
Step 1
Step 2
Step 3
Step 4
Other
Registration is complete when the VIPER home
managements center opens. You are now ready to
install each of the sensors.
Select each of the devices and name them for the location they
will be placed.
Select Go to fi rst
time registration
page
Click Register