Whirlpool ADG 8310 Instruction For Use Manual

Download User manual manual of Whirlpool ADG 8310 Monitor for Free or View it Online on All-Guides.com.

Brand: Whirlpool

Category: Monitor

Type: User manual manual for Whirlpool ADG 8310

Pages: 8 (3.75 Mb)

Download Whirlpool ADG 8310 User manual manual

Whirlpool ADG 8310 User	manual	manual - Page 1
1
Whirlpool ADG 8310 User	manual	manual - Page 2
2
Whirlpool ADG 8310 User	manual	manual - Page 3
3
Whirlpool ADG 8310 User	manual	manual - Page 4
4
Whirlpool ADG 8310 User	manual	manual - Page 5
5
Whirlpool ADG 8310 User	manual	manual - Page 6
6
Whirlpool ADG 8310 User	manual	manual - Page 7
7
Whirlpool ADG 8310 User	manual	manual - Page 8
8
GB
-1-
Chart
(see at right for options description)
PROGRAMME SELECTION BUTTON
Press button “P” (repeatedly) until the
required programme number appears on
the display (see “Table of programmes”
below).
START BUTTON
The indicator lights up during operation,
flashes when a fault occurs and goes off at
the end of the programme.
ON
BUTTON
OFF
BUTTON
FAULT INDICATION AND WASH TIME DISPLAY
In normal operation it indicates the remaining time (h:mm), whereas with
“Delayed start” selected it indicates the time remaining until programme
start (hh).
If “F..” appears on the display, see chapter “What to do if...”.
RESET BUTTON
For programme change or indication of faults.
Press this button to cancel a started programme and selected extra
options. Press this button to cancel the main fault indicators “F..”
also refer to the chapter “What to do if...”. The programme can then
be selected and started.
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary
depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance’s automatic calibration system.
2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “[email protected]”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
Table of programmes
Deter-
gent
Consumption
P
Programmes
Available
options
Loading instructions
Litres kWh
Minutes
1)
1
Aqua Steam 40-70°C
Delay
Multizone
Power Clean
Normally or heavily soiled crockery,
including pots and pans. Thanks to
steam action, soaking or hand
pretreatment is no longer needed. In
addition hygiene is ensured due to the
high temperature steam.
X 7-15 0.99-1.75 65-205
2
Pre-Wash cold
Delay
Multizone
Crockery to be washed later. 4.0 0.03 14
3
Glasses 40°C
Delay
Multizone
Light soiling, for example glasses and
cups.
X 10.0 0.85 100
4
Quickwash 45°C
Delay
Multizone
Lightly soiled crockery, with no
dried-on food.
*
Not recommended tablets use.
X
*
11.0 0.80 30
5
Eco
2)
50°C
Delay
Multizone
Power Clean
Normally soiled crockery.
Energy-saving programme.
X 11.0 1.05 170
6
Antibacterial
3)
Delay
Multizone
Power Clean
Normally or heavily soiled crockery,
with additional antibacterial wash.
Programme interruption (e.g. due to
door opening) can compromise
elimination of germs.
X 13.0 1.50 115
7
Overnight 55°C
Delay
Multizone
Normally soiled crockery, gentle and
quiet thanks to the lower spray
pressure (39dbA).
X 13.0 1.20 290
5019 396 01792ADG 8310
Options and display description
BEFORE USING THE APPLIANCE FOR THE
FIRST TIME CAREFULLY READ THIS QUICK
REFERENCE GUIDE AND THE ASSEMBLY
INSTRUCTIONS! THE GUARANTEE IS NOT
APPLICABLE IF FAULTS ARE CAUSED BY
INCORRECT USE OF THE APPLIANCE.
HALF LOAD/
MULTIZONE
Allows you to choose
the washing zones.
Press this button
(repeatedly) to select
the wash zones:
both racks
only upper
rack
only lower
rack
POWER CLEAN
Thanks to the
additional power jets
this option provides a
more intensive and
powerful wash in the
lower rack, in the
specific area. This
option is
recommended for
washing pots and
casseroles
(see
page 4)
. Press this
button to activate
Power Clean (the
indicator lights up).
RINSE AID
INDICATOR
When lit, the rinse aid
dispenser needs to be
refilled.
SALT INDICATOR
When lit, the salt
reservoir needs to be
refilled.
SET THE
DETERGENT
Press this button
(repeatedly) to set the
type of detergent used.
Powder, gel
(standard)
Detergent
with rinse aid
Detergent
with salt +
rinse aid
DELAYED START
BUTTON
Press the button
(repeatedly) to delay
the start of the
programme.
Adjustable from 1 to 24
hours. With each press
of the button, the
delayed start indicator
increases by one hour
and after 24 resets
from 00. Then press
the START button. The
dishwasher will start
after the set time.
Quick reference guide