• Home
• Brands
• a/d/s/ Manuals
• a/d/s/ 345cs
• a/d/s/ 345cs Owner's Manual

A/d/s/ 345cs Owner's Manual

Download Owner's manual of a/d/s/ 345cs Speakers for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

features

Molded woofer basket - The backbone of any good woofer is its basket. It provides the proper alignment

and support structure for the magnet and moving parts while the very thin braces guarantee a minimum of

early reflections off the basket that would be ordinarily transmitted as sonic colorations through the cone.

Woofer cone - Anodized aluminum cones provide the perfect combination of rigidity and low moving

mass for ultra-low distortion and superior transient response.

Vented voice coil - Magnet cooling vent construction enhances power handling capabilities of the

woofer.

Extended center pole - Woofer magnet geometry provides a symmetrical magnetic pattern to reduce THD.

Tweeter - Ultra-light silk dome design is treated with polymer compound to control all non-linear resonances.

Multi-mount tweeter - The following mounting options (surface, angled surface, flush, or angled flush)

are supplied to mount the ferrofluid cooled neodymium tweeter.

Tweeter level control - A three-position switch adjusts the volume of the tweeter with respect to the

midrange.

Tweeter phase switch - A two-position switch which allows 180° or 0° phase difference between the

tweeters and midranges.

Midrange contour control - A two-position switch offers a frequency response correction circuit to

adjust for flat frequency response in the car on axis or off axis.

Bi-amplifiable/ bi-wirable - The passive crossover supplied with this system is bi-amplifiable or bi-

wirable; typically only available in high quality audiophile home loudspeakers.

Solid state tweeter protection - Advanced protection circuitry provides protection for the tweeter

against overpowering or amplifier clipping.

cautions

Study your automobile thoroughly before you drill or cut any holes. Take extra care when working near

gas tanks, gas lines, brake or hydraulic lines and electrical wiring.

Wear eye and ear protection when using power tools. Keep the woofers and tweeters away from metal

filings and shavings. Once foreign objects are stuck to the magnets or tweeter dome, it will be virtually

impossible to remove them. Keep the tweeters in their protective bags until final mounting to prevent any

possibility of metal dust or chips from passing through the grille and accumulating on the dome.

Exercise caution when working with the cs series with the grille removed. A slip of the hand with a

screwdriver or other tool can result in irreparable damage to the cone or dome. Do not touch the cone

or dome.

Do not install the components where they will be subject to excessive heat, moisture or dust, or where

they will be kicked or repeatedly bumped or brushed.

Make absolutely sure that the woofer is connected to the lowpass output and the tweeter is connected

to the highpass output of the crossover network. If these connections are reversed, low-frequency signals

will be fed to the tweeter without fuse protection. In this case, the tweeter may be damaged, such

damage is not covered by the warranty.

When removing or installing the grills be careful not to brush the woofer's rubber surround or the

tweeter's dome with the edge of the grille. Cutting or tearing the surround or dome will destroy the unit.

2