Installer: please leave these
instructions with consumer.
Consumer: please retain for
future reference.
AVAILABLE IN THE
FOLLOWING LOG STYLES
Classic Oak
18" Model No. 6500742. 6 (Nat)
18" Model No. 4500741.6 (LP)
24" Model No. 7400742.6 (Nat)
24" Model No. 5500741.6 (LP)
30" Model No. 9600742,6 (Nat)
30" Model No. 6500741.6 (LP)
Classic Designer Oak
18" Model No. 6500742.7 (Nat)
18" Model No. 4500741.7 (LP)
24" Model No. 7400742,7 (Nat)
24" Model No. 5500741.7 (LP)
30" Model No. 9600742.7 (Nat)
30" Model No. 6500741.7 (LP)
Classic Split Oak
18" Model No. 6500742.8 (Nat)
18" Model No. 4500741.8 (LP)
24" Model No. 7400742.8 (Nat)
24" Model No. 5500741.8 (LP)
30" Model No. 9600742.8 (Nat)
30" Model No. 6500741.8 (LP)
Classic Series
VENTED GAS FIREPLACE LOG SET
A.G.A./C.G.A. CERTIFIED
INSTALLATION AND
OPERATING INSTRUCTIONS
WARNING: Improper installation, adjust-
ment, alteration, service or maintenance
can cause injury or property damage. Refer
to this manual. For assistance or additional
information consult qualified installer, ser-
vice agency or the gas supplier.
FOR NATURAL OR PROPANE GAS
FOR YOUR SAFETY I
Do not store or use gasoline or other flam- I
mable vapors and liquids in the vicinity of
this or any other app ance.
FOR YOUR SAFETY
WHATTO DO IF YOU SMELL GAS
1. Do not try to light any appliance
2. Do not touch any electrical switch;
do not use any phone in your building.
3. Immediately call your gas supplier from
a neighbor's phone and follow the gas
supplier's instructions.
4. If you cannot reach your gas supplier,
call the fire department
IMPORTANT: READ THESE INSTRUCTIONS I
CAREFULLY BEFORE STARTING I
INSTALLATION OF YOUR LOG SET I
Your Williams Log Set is to be installed only in a solid-fuel
burning fireplace with a working flue constructed of noncom-
bustible material. Solid fuels shall not be burned in a fireplace
where a gas log set is installed. The minimum permanent vent
opening provided by the fireplace chimney or chimney damp-
er to vent the flue products is listed on page 2. The chimney
damper must be fixed in a manner to maintain the minimum
permanent vent opening. The installation, including provi-
sions for combustion and ventilation air, must conform with
the American National Standard National Fuel Gas Code
Z223.1 and applicable local building codes. In Canada, the
installation must conform with the current CAN/CGA B149.1
and B149.2 Installation Code.
WILLIAMS FURNACE COMPANY 225 Acacia Street, Colton, CA 92324 USA (800) 266-0993
1 No. P923231
