Emerson 1F78 Installation Instructions Manual

Download Installation instructions manual of Emerson 1F78 Thermostat for Free or View it Online on All-Guides.com.

Brand: Emerson

Category: Thermostat

Type: Installation instructions manual for Emerson 1F78

Pages: 16 (3.35 Mb)

Download Emerson 1F78 Installation instructions manual

Emerson 1F78 Installation instructions manual - Page 1
1
Emerson 1F78 Installation instructions manual - Page 2
2
Emerson 1F78 Installation instructions manual - Page 3
3
Emerson 1F78 Installation instructions manual - Page 4
4
Emerson 1F78 Installation instructions manual - Page 5
5
Emerson 1F78 Installation instructions manual - Page 6
6
Emerson 1F78 Installation instructions manual - Page 7
7
Emerson 1F78 Installation instructions manual - Page 8
8
Emerson 1F78 Installation instructions manual - Page 9
9
Emerson 1F78 Installation instructions manual - Page 10
10
Emerson 1F78 Installation instructions manual - Page 11
11
Emerson 1F78 Installation instructions manual - Page 12
12
Emerson 1F78 Installation instructions manual - Page 13
13
Emerson 1F78 Installation instructions manual - Page 14
14
Emerson 1F78 Installation instructions manual - Page 15
15
Emerson 1F78 Installation instructions manual - Page 16
16
Failure to follow and read all instructions carefully
before installing or operating this control could cause
personal injury and/or property damage
Installation Instructions for
Heating & Air Conditioning
1F78
5/2 Day Programmable Thermostat
CONTENTS
Preparations .................................................. 1
Thermostat Details ........................................ 1
Removing Old Thermostat ............................. 1
Mounting and Wiring ...................................... 2
Check Thermostat Operation ......................... 3
Programming your Thermostat ...................... 4
Specifications ................................................ 6
Troubleshooting ............................................. 6
YOUR THERMOSTAT REPLACES
Typical System Compatibility Chart 1F78
Standard Heat Only Two Wire Gas or Oil Fired Systems (24 volt) Yes
Electronic Ignition Heat Only Two Wire Systems (24 volt) Yes
Electronic Ignition Heat Only Gas or Oil Fired Systems (24 volt) Yes
Standard Heat/Cool Systems (24 volt) Yes
Heat/Cool Systems Electric Heat (24 volt) Yes
Heat Only Electric Heat Systems (24 volt) Yes
Cool Only Systems (24 volt) Yes
Heat Pump Systems (No Aux or Emergency Heat) Yes
Hot Water Zone Heat Only (Two Wire) Systems Yes
Hot Water Zone Heat Only (Three Wire) Systems No
Line Voltage Heating or Baseboard 110/240 Volt Systems No
Millivolt Systems Floor or Wall Furnaces Yes
12 VDC Mobile Home Application Yes
Multistage Systems No
Systems Exceding 30VAC, 1.5 Amp No
2
THERMOSTAT DETAILS
HAND OR POWER
DRILL WITH 3/16 INCH
DRILL BIT, IF NEEDED
FLAT BLADE SCREWDRIVER
WIRE CUTTER/STRIPPER
1
PREPARATIONS
To prevent electrical shock and/or equipment damage,
disconnect electrical power to the system at the main fuse
or circuit breaker until installation is complete.
CAUTION
!
Before removing wires from old thermostat’s switching subbase,
label each wire with the terminal designation it was removed
from.
1. Remove Old Thermostat: A standard heat/cool thermostat
consists of three basic parts:
a. The cover, which may be either a snap-on or hinge type.
b. The base, which is removed by loosening all captive screws.
c. The switching subbase, which is removed by unscrewing
the mounting screws that hold it on the wall or adaptor plate.
2. Shut off electricity at the main fuse box until installation is
complete. Ensure that electrical power is disconnected.
3. Remove the front cover of the old thermostat. With wires still
attached, remove wall plate from the wall. If the old thermostat
has a wall mounting plate, remove the thermostat and the wall
mounting plate as an assembly.
4. Identify each wire attached to the old thermostat.
5. Disconnect the wires from the old thermostat one at a time. DO
NOT LET WIRES FALL BACK INTO THE WALL.
6. Install new thermostat using the following procedures.
White-Rodgers is a division
of Emerson Electric Co.
www.white-rodgers.com
PART NO. 37-6614B
Replaces 37-6614A
0731
Figure 1. Thermostat base
Assemble tools required below.
REMOVING OLD THERMOSTAT
W
RH
B RC
G
O
Y
+
-
+
-
GAS
ELEC
0W9 4
0W9 5
Figure 1. Thermostat base
Mounting
hole
Mounting
hole
W905
Clip for
Hydronic
System
W904
Clip for
Celsius Display
Electric/Gas
Switch
W9 03
W903
Clip to
Disable
EMR
Feature