Eminent LFT-8b Diaphragm Replacement
Download Diaphragm replacement of Eminent LFT-8b Speakers, Transducer for Free or View it Online on All-Guides.com.
Brand: Eminent
Category: Speakers , Transducer
Type: Diaphragm replacement for Eminent LFT-8b
Pages: 2 (0.08 Mb)
1
2
TWEETER DIAPHRAGM REPLACEMENT FOR THE LFT-8b
Revised 10/26/2007
Remove the tweeter driver completely from the speaker frame. Disconnect the
black tweeter wire spade lug from the barrier terminal block and detach the white tweeter
wire from the mid-range terminal board using a soldering iron. Remove the eight
machine screws, nuts and spacers. Keep track of each spacer location so that it can be
returned to that same position upon re-assembly. Place the tweeter driver on a smooth,
clean surface with its front assembly, facing down. Remove four 10-32 machine screws
from one end of the tweeter driver assembly. Pull apart the back magnet assembly from
the front (approx. 1”) at this end. Continue pulling apart the channels while removing the
next three pairs of screws, taking care not to allow the front and back channels to slap
together. Loosen the remaining screw at the end and pivot the top channel clear of the
bottom channel at right angles from each other. Remove the screw and separate the two
halves.
Replacing The Tweeter Diaphragm
Remove the old diaphragm along with the underlying double-sided tape on both
rows of magnets from “front” channel making sure the rubber insulator squares stay
intact. Please note placement and location of the diaphragm before removal, as to
reference the location for the replacement diaphragm. Check for and remove any
magnet fragments from the front and back channels. Place the new tweeter diaphragm on
a hard top table with the terminal board facing down and aluminum conductor facing up.
Tape the non-terminal end of the diaphragm to the table using ½” wide invisible (office)
tape. Tension and tape the other end of the diaphragm just above the terminal board
using a 3” piece of invisible tape. Make sure the diaphragm is flush with the table with
no wrinkles or creases above the terminal board. Place an 18 ¾” piece of ½” wide
double-sided tape on the outer three conductor ribbons of the diaphragm, starting at the
non-terminal end and ending around 4 ½” from the terminal board. Cover the final 3” of
conductor ribbons, including the terminated leads, with invisible tape. Carefully remove
the diaphragm for the table and place the diaphragm by first attaching the non-terminal
end flush with either end of the front channel assembly. Next, tension the diaphragm and
align the conductors with the channel while pushing the diaphragm onto the magnets
making sure the diaphragm is flat between the magnet channels as you go. The
diaphragm should resemble Diagram (A). Fold and tape the over-hanging terminal end
of the diaphragm as illustrated in Diagram (B).