Emprex 9019URF Quick Installation Manual

Download Quick installation manual of Emprex 9019URF Keyboard for Free or View it Online on All-Guides.com.

Brand: Emprex

Category: Keyboard

Type: Quick installation manual for Emprex 9019URF

Pages: 8 (1.91 Mb)

Download Emprex 9019URF Quick installation manual

Emprex 9019URF Quick installation manual - Page 1
1
Emprex 9019URF Quick installation manual - Page 2
2
Emprex 9019URF Quick installation manual - Page 3
3
Emprex 9019URF Quick installation manual - Page 4
4
Emprex 9019URF Quick installation manual - Page 5
5
Emprex 9019URF Quick installation manual - Page 6
6
Emprex 9019URF Quick installation manual - Page 7
7
Emprex 9019URF Quick installation manual - Page 8
8
9019URF QG
3100506040 v1.0
9019URF Keyboard with Mouse & Dual Mode Joystick Mouse
Quick Installation Guide
Hardware Installation
Front View of USB Connector Back View of USB Connector
1. Plug in the receiver connector into your
available USB port on PC.
2. Take the keyboard and make sure the
batteries on the back are installed correctly.
(Follow the polarity signs in the battery
compartment.)
110V
(+)
(-)
1.5V 2pcs
ID Button Setting
This ID-recognition function helps to protect
against interference from other RF keyboards in
the same environment. Remember to set the ID
when you replace the batteries or your keyboard
kits do not work properly.
The word CONNECT labels the ID button on
each unit.
The LED under ID button of receiver shows
connecting condition.
1. Your PC must be on to change the ID setting.
2. Press ID button on the top of the receiver
once.
3. Press ID button on the upper-left corner on
the keyboard front side once.
Attention: The whole procedure should be
completed within 1 minute.
ID Button(LED)
Mouse Right Button
ID Button
Scroll Down
Sticker
Mouse Middle Button
Scroll Up
Mouse Left Button
Software Installation
In order to take advantage of the special button functionality of the keyboard you will have to
install the keyboard driver which is located on the driver disk included in the box.
1. Remove any existing keyboard software from the computer.
2. Insert the driver CD in your computers, and run "SetupKey.exe".
3. Follow the on screen instructions to finish the installation procedure. The driver default will
be installed at C:\Program Files\KMaestro.
The driver icon
will show on Windows system tray when all setup procedures are finished,
the operating system need not to be restarted.
Plugging in USB
Connector
Bottom view of
9019URF
keyboard
ID Button on Receiver
(With a LED under the ID button)
Front View of 9019URF Keyboard