• Home
• Brands
• Epic Fitness Manuals
• Epic Fitness View 550 Treadmill
• Epic Fitness View 550 Treadmill Manual

Epic Fitness View 550 Treadmill Manual

Download Manual  of Epic Fitness View 550 Treadmill Other, Treadmill for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

33

34

35

36

37

38

39

40

16

HOW TO TURN ON THE POWER

IMPORTANT: If the treadmill has been exposed to

c

old temperatures, allow it to warm to room tem-

perature before turning on the power. If you do not

d

o this, you may damage the console displays or

other electrical components.

Plug in the power cord (see

page 14). Next, locate the

power switch on the treadmill

frame near the power cord.

Make sure that the switch is

in the reset position.

IMPORTANT: The console features a display demo

mode, designed to be used if the treadmill is dis-

played in a store. If the displays light as soon as

you plug in the power cord and press the power

switch into the reset position, the demo mode is

turned on. To turn off the demo mode, hold down

the Stop button for a few seconds. If the displays

remain lit, see THE INFORMATION MODE on page

26 to turn off the demo mode.

Next, stand on the foot rails

of the treadmill. Locate the

clip attached to the key,

and slide the clip securely

onto the waistband of your

clothes. Then, insert the

key into the console. After a

moment, the displays will light. IMPORTANT: In an

emergency, the key can be pulled from the con-

sole, causing the walking belt to slow to a stop.

Test the clip by carefully taking a few steps back-

ward; if the key is not pulled from the console, ad-

just the position of the clip.

IMPORTANT: If there is a sheet of plastic on the

face of the console, remove the plastic. To prevent

damage to the walking platform, wear clean ath-

letic shoes while using the treadmill. The first time

the treadmill is used, observe the alignment of the

walking belt, and center the walking belt if neces-

sary (see page 30).

Note: The console can display speed and distance in

either miles or kilometers. To find out which unit of

measurement is selected or to change the unit of mea-

surement, see THE INFORMATION MODE on page

26. For simplicity, all instructions in this section refer to

miles.

HOW TO USE THE MANUAL MODE

1. Insert the key into the console.

See HOW TO TURN ON THE POWER at the left.

2. Select the manual mode.

Each time the key is in-

serted, the manual

mode will be selected. If

you have selected a

workout, press any of

the workout buttons re-

peatedly until a track appears in the matrix.

3. Start the walking belt and adjust the speed.

To start the walking belt, press the Start/Stop but-

ton, one of the Speed increase buttons, or one of

the speed buttons numbered 1 to 12.

If you press the Start button or one of the Speed

increase buttons, the walking belt will begin to

move at 1 mph. As you exercise, change the

speed of the walking belt as desired by pressing

the Speed increase and decrease buttons on the

console or in the right handrail. Each time you

press a button, the speed setting will change by

0.1 mph; if you hold down the button, the speed

setting will change in increments of 0.5 mph. If you

press one of the numbered speed buttons, the

walking belt will gradually change speed until it

reaches the selected speed setting.

To stop the walking belt, press the Start/Stop but-

ton. To restart the walking belt, press the

Start/Stop button, one of the Speed increase but-

tons, or one of the numbered speed buttons.

4. Change the incline of the treadmill as desired.

To change the incline of the treadmill, press one of

the Incline increase or decrease buttons or one of

the incline buttons numbered 0 to 12. Each time

you press one of the Incline buttons, the incline will

gradually change until it reaches the selected in-

cline setting.

Reset

Clip

Key