Epson Stylus CX5400 Start Here Manual

Download Start here manual of Epson CX5400 - Stylus Color Inkjet All in One Printer, Printer for Free or View it Online on All-Guides.com.

Epson CX5400 - Stylus Color Inkjet Start here manual - Page 1
1
Epson CX5400 - Stylus Color Inkjet Start here manual - Page 2
2
Epson CX5400 - Stylus Color Inkjet Start here manual - Page 3
3
Epson CX5400 - Stylus Color Inkjet Start here manual - Page 4
4
Epson CX5400 - Stylus Color Inkjet Start here manual - Page 5
5
Epson CX5400 - Stylus Color Inkjet Start here manual - Page 6
6
Epson CX5400 - Stylus Color Inkjet Start here manual - Page 7
7
Epson CX5400 - Stylus Color Inkjet Start here manual - Page 8
8
1 Set the feeder guard into its two slots at the back of the Stylus CX.
2 Insert the paper support into its two grooves behind the
feeder guard.
EPSON Stylus
®
CX5400
Start Here
1 Lift up the entire scanner unit.
2 Shake the package of ink cartridges four or five times.
Then remove the cartridges from the package.
Caution: You must install all cartridges and leave them installed
for all types of printing. To avoid damaging the Stylus CX, never
move the print head by hand.
3 Lower each cartridge into
its holder as shown.
4 Press down on each cartridge
until it is firmly seated.
Install Ink Cartridges
5
1 Flip the feeder guard forward.
2 Slide out the edge guide.
3 Place a stack of paper against the right side of the feeder,
but don’t push it in. Slide the edge guide against the paper.
4 Flip the feeder guard back over the stack of paper.
1 Open the scanner lid, as shown.
Remove any packing materials
under the lid.
2 Slide the transportation lock
to the unlocked position.
Caution: Make sure you
unlock the scanner, or it
won’t work.
3 Close the scanner lid.
1 Make sure you have all the parts shown here. If any parts are missing,
contact EPSON as described on the back of this sheet.
2 Remove all tape, as shown.
Note: There may be packing materials or tape in different locations.
3 Lift up the entire scanner
unit. If it doesn’t open,
make sure you have
removed all the tape.
4 Peel off the tape from the
ink cartridge holder and
from the top of the printer.
Make sure you don’t leave
any tape inside.
5 Lower the scanner unit.
Unpack
Unlock
Turn over
1 Plug the Stylus CX into a grounded electrical outlet.
Do not connect the USB cable yet.
2 Press and hold the On button until the green light comes on.
Plug In and Turn On
1
2
On
Error
Scan
Reset
Reset all(3sec)
Recall
Save(3sec)
2
4
6
Load Paper
5 Lower the scanner unit.
The Stylus CX begins charging the ink delivery system.
Charging takes about 2 minutes. The green light flashes and the
Stylus CX makes various sounds. Don’t turn it off while the green
light is flashing or you’ll waste ink.
continued
Attach the Parts
3
Paper support USB cable
Software
CD-ROM
Quick Reference
Guide
EPSON Stylus CX5400
Ink cartridges Feeder guard
On button
continue
Don’t remove
this sticker yet
Don’t touch the green part
4046293-00 CPD-16736
Remove tape and
open the output tray