Tandberg Data LTO-3 Quick Start
Download Quick start of Tandberg Data LTO-3 Storage for Free or View it Online on All-Guides.com.
Brand: Tandberg Data
Category: Storage
Type: Quick start
Model: Tandberg Data LTO-3 , Tandberg Data LTO-4
Pages: 2 (0.3 Mb)
1
2
Printed on at least 50% total recycled fiber with at least 10%
post-consumer paper
© 2008 Tandberg Data
Printed in the EU
www.tandbergdata.com
Part No. 433868-01
EH914-90902
REAR
FRONT
SAS
controller (HBA)
Connector
on HBA
Connector on
tape drive
1 Refer to www.tandbergdata.com
Before you install your tape drive, always refer to www.tandbergdata.com to find out:
• Is connection to your SAS server supported?
• Can you connect to the host SAS controller or do you need to purchase an
additional HBA?
• If you connect to a new HBA, can you use the supplied cable or must you
purchase an additional cable.
This poster describes how to connect a Tandberg LTO-3 and LTO-4 SAS tape drive
on a SAS server.
WARNING:
To avoid personal injury or damage to the server or tape drive,
disconnect your server from the mains power supply before installing the tape
drive. To avoid damage to server or tape drive observe all recommended
anti-static and power-grounding precautions, as specified in your server and
tape drive manuals.
Tandberg LTO-3 and LTO-4
HH SAS Internal Tape Drives
2 Install and connect to host HBA
The following instructions are valid ONLY for servers with an HBA that supports
internal SAS ports. You must purchase a supported HBA and cable, if you do not
already have a SAS card installed. See www.tandbergdata.com for recommended
products. You need a spare PCI slot for the new HBA.
1. If necessary install the new HBA
Follow the instructions supplied with the HBA to install the new SAS HBA.
2. Attach the mounting hardware (some servers only)
Screw packs are labeled for each server type; always use the specific screws for your
server. Follow the instructions in the screw pack. You may damage your tape
drive if you use screws that are too long, because the Tandberg LTO half-height
tape drive allows only 3mm of the engagement of the screw into the drive.
NOTE: The illustration shows one method of mounting hardware; it does not
apply to all servers. Please refer also to the "User Guide" and your server
documentation.
3. Install the tape drive
Install the tape drive, as described in the "User Guide".
TIP:
If cable access for the tape drive bay is awkward, it may be easier to
access power and other connections if the tape drive is installed in the top bay.
You may need to move other devices to lower bays to achieve this.
4.
Connect the SAS cable supplied with the tape drive to the new
HBA and the tape drive.
Do not use screws
attached to device
you are replacing
NO
Do not use screws
attached to server
NO
Use screws supplied
with new tape drive
YES
C
M
Y
CM
MY
CY
CMY
K
Tandberg HH SAS Int front.pdf 11/4/08 17:05:17