Epson Stylus C66 Start Here Manual

Download Start here manual of Epson Stylus C66 All in One Printer, Printer for Free or View it Online on All-Guides.com.

Epson Stylus C66 Start here manual - Page 1
1
Epson Stylus C66 Start here manual - Page 2
2
Epson Stylus C66 Start here manual - Page 3
3
Epson Stylus C66 Start here manual - Page 4
4
Epson Stylus C66 Start here manual - Page 5
5
Epson Stylus C66 Start here manual - Page 6
6
Epson Stylus C66 Start here manual - Page 7
7
Epson Stylus C66 Start here manual - Page 8
8
Epson Stylus
®
C66
Start Here
Follow the steps in this section to install the software for your operating
system.
Windows XP
1 Make sure your printer is connected to your computer and turned on.
Then turn on your computer.
2 Wait for Windows to detect your printer and display a screen like this:
DON’T CLICK ANY BUTTONS ON THIS SCREEN.
Note: If a screen like this doesn’t appear, make sure your printer
is turned on and connected.
3 Put the Epson CD in your CD-ROM or DVD drive and wait a few
seconds for the CD to be recognized.
Your printer software installs automatically and various messages
appear on the screen.
4 When installation halts, click Finish.
5 You see the license agreement. Read the agreement and click Agree.
You see the Options Menu. Continue with the instructions in
“Finishing Software Installation” on the back of this sheet to
complete the software installation.
Install Software
6
1 Lower the printer’s output tray, pull out the extension and open
the printer cover.
2 Shake the package of ink cartridges four or five times. Then remove
the cartridges from the package. (Don’t shake them after removing the
packaging.)
3 Open the cartridge cover.
1 Make sure you have all the parts shown here. If any parts are missing,
contact Epson as described on the back of this sheet.
2 Remove any tape and packing material inside and around the printer.
The tape may be in slightly different places on your printer, so check
carefully.
3 Remove the tape and insert securing the ink cartridge holder.
4 Slide the paper support into the slot on the back of the sheet feeder.
The paper support should fit securely.
Unpack
Install Ink Cartridges
1
2
3
Paper support Power cord
Software
CD-ROM
Quick Guide
Printer
Ink cartridges
continue
4050351-00 XXX
Don’t touch the green
circuit boards or
remove any labels
4 Lower each ink cartridge into its holder with the green circuit board
facing the front.
Then gently push each ink cartridge down until it is firmly seated.
The color of the cartridge label should match the marker on the
holder.
5 Close the cartridge cover.
6 Close the printer cover and press the ink button.
The green power light flashes as your printer charges ink
for several seconds.
Caution: Don’t turn off the printer while the green power light
is flashing, unless the printer hasn’t moved or made noise for
more than 5 minutes.
continued
1 Make sure your computer is turned off. Keep it turned off until
section 6, “Install Software.”
2 Plug the flat end of the cable into any available USB port
on your computer.
3 Plug the square end of the cable into the USB port
on your printer.
Connect the Printer
4
1 Fan a few sheets of paper and place them against the right edge
guide. Make sure the paper is under the tabs on the edge guides.
2 Press in the side of the left edge guide and slide it against the paper,
but not too tightly.
Load Paper
5
Turn over
1 Connect the printer’s power cord to the printer, then plug it
into a grounded electrical outlet.
2 Press the printer’s power button until the green power light
comes on.
Caution: Use only the printer’s power button to turn the
printer on and off.
Power On
2
2
Remove tape
and insert
Do not touch
or remove the
white cable
Don’t load paper
above this arrow