TEAC HD-P2 Quick Start Manual
Download Quick start manual of Teac HD-P2 MP3 Player for Free or View it Online on All-Guides.com.
1
2
3
4
» HD-P2 Quick Start Guide
1
First Recording
Apply power
Connect the AC power adaptor to your HD-P2; turn
it ON by momentarily pressing the spring-loaded
p o w e r s w i t c h . T h e H D - P 2 w i l l p o w e r u p
immediately. The HD-P2’s operating system is
stored in internal memory, not the CF card, so you
can turn on the HD-P2 without a CF card inserted.
Adjust the Display
Press the DISPLAY key. Turn the DATA wheel to
adjust Contrast for optimal viewing. Press the
DISPLAY key again. Turn the DATA wheel to
adjust Brightness. Press the CANCEL key to end
adjustments. These settings are remembered when
the unit is power cycled.
Insert Media
Insert a media card into the media slot. The HD-P2
will ask if you would like to format the media. If
this is the first time the media has been used with
the HD-P2 (and it has no other data you wish to
keep) press the SELECT key to format the media.
Once formatting is complete the HD-P2 will make
a default project (PROJ0001) and return to the main
screen.
Record Audio
Flip the LEFT INPUT and RIGHT INPUT switches
(top of unit) to MIC. Set the MIC switch to INT.
Press the PAUSE key to enter Monitor mode and
while speaking into the Microphone adjust the input
Levels using the on-screen meters. Press the REC
key and speak into the microphone for a short test.
Press the STOP key when you are done.
Play Audio
Return to the beginning of the audio you just
recorded by pressing the STOP+REW or LOCATE
Ô key. Press the PLAY key. Adjust the Monitor
(Headset) level control to hear the audio in the
speaker, or headset if one is plugged in. Note that
connecting a headset disables the built-in speaker.
Create a New Project
1. Hold the MENU key and press the PROJECT key
2. Use the DATA wheel to scroll to Create New
Project
3. Press the SELECT key
4. Use the DATA wheel to scroll to Use Default
Template
5. Press the SELECT key
6. Press the SELECT key again to confirm (or
wait two seconds)
Load A Project
1. Hold the MENU key and press the PROJECT key
2. Use the DATA wheel to scroll to the project to
be loaded
3. Press the SELECT key
4. Load Project should already be selected
5. Press the SELECT key
Delete A Project
1. Hold the MENU key and press the PROJECT key
2. Use the DATA wheel to scroll to the project to
be deleted
3. Press the SELECT key
4. Use the DATA wheel to scroll to Delete
5. Press the SELECT key
6. Press the SELECT key again to confirm this
action cannot be undone
Rename A Project
1. Press the MENU key
2. Use the DATA wheel to scroll to Project
Menu (this references the currently loaded
project)
3. Press the SELECT key
4. Use the DATA wheel to scroll to Rename
5. Press the SELECT key to enter the naming
interface