Epson WorkForce 30 Start Here Manual

Download Quick start manual of Epson C11CA19201 - WorkForce 30 Color Inkjet Printer Printer, Projector for Free or View it Online on All-Guides.com.

Epson C11CA19201 - WorkForce 30 Color Inkjet Printer Quick start manual - Page 1
1
Epson C11CA19201 - WorkForce 30 Color Inkjet Printer Quick start manual - Page 2
2
Epson C11CA19201 - WorkForce 30 Color Inkjet Printer Quick start manual - Page 3
3
Epson C11CA19201 - WorkForce 30 Color Inkjet Printer Quick start manual - Page 4
4
Epson C11CA19201 - WorkForce 30 Color Inkjet Printer Quick start manual - Page 5
5
Epson C11CA19201 - WorkForce 30 Color Inkjet Printer Quick start manual - Page 6
6
Epson C11CA19201 - WorkForce 30 Color Inkjet Printer Quick start manual - Page 7
7
Epson C11CA19201 - WorkForce 30 Color Inkjet Printer Quick start manual - Page 8
8
2 Open the output tray and pull out the extensions.
3 Squeeze the edge guide and slide it left.
4 Load paper against the right edge guide and behind the tab, with the
printable side face up.
Note: Don’t load the paper sideways; always load it short edge first.
5 Slide the edge guide over.
Note: Don’t load paper before installing the ink cartridges.
1 Lift up the printer cover.
2 Open the cartridge cover.
3 Shake the ink cartridges, then unpack them.
4 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals from the cartridges.
5 Insert the cartridges in the holder for each color.
Load paper
4
Caution: Do not open ink cartridge packages until you are ready to install the ink.
Cartridges are vacuum packed to maintain reliability.
If anything is missing, contact Epson
®
as described on the back of this sheet.
Unpack
1
Start Here
Please read these instructions before using the printer.
6 Press the cartridges down until they click.
7 Close the ink cartridge cover and press it down until it clicks.
8 Close the printer cover.
9 Press the ink button to charge ink. Charging takes about 2.5 minutes.
Caution: Don’t turn off the printer while the power light is flashing or you’ll
waste ink.
1 Connect the power cable.
2 Press the power button.
Turn on the printer
2
1 Open the paper support.
Install ink cartridges
3