Epson PowerLite S4 Quick Setup Manual

Download Quick setup manual of Epson 3LCD - PowerLite S4 Projector Printer, Projector for Free or View it Online on All-Guides.com.

Epson 3LCD - PowerLite S4 Projector Quick setup manual - Page 1
1
Epson 3LCD - PowerLite S4 Projector Quick setup manual - Page 2
2
Epson 3LCD - PowerLite S4 Projector Quick setup manual - Page 3
3
Epson 3LCD - PowerLite S4 Projector Quick setup manual - Page 4
4
Epson 3LCD - PowerLite S4 Projector Quick setup manual - Page 5
5
Epson 3LCD - PowerLite S4 Projector Quick setup manual - Page 6
6
Choosing a location
The projector supports 4 viewing setups. Choose the best one for
your environment. If you install the projector in a rear or overhead
position, you’ll need to choose the correct projection option,
identified below, from the Extended menu. See the User’s Guide
on your CD-ROM for instructions.
Table
Convenient for temporary front projection.
Choose Front from the menu.
Ceiling
Professional installation recommended.
Choose Front/Ceiling from the menu.
Rear
For permanent installation behind a
translucent screen. Choose Rear
from the menu.
Rear/Ceiling
Professional installation behind a translucent
screen recommended. Choose Rear/Ceiling
from the menu.
The distance between the projector and the screen determines the
size of the image. The diagram below shows approximately how big
your image will be, based on where you set up the projector.
1 Unpack the projector
You should have the following items:
Quick Setup
2 Connect your video source
Connect the projector to a computer or video source using any of the available
connections shown below.
Check the connectors on your video equipment. If more than one
connection is available, choose the one that provides the best quality.
(The projector connectors from highest to lowest quality are
Computer/Component Video, S-Video, and Video.)
A computer cable is included. You can purchase optional video cables
through Epson or at local electronics stores. See the next page for
accessory information.
You can connect up to 3 video devices and use the remote control to
switch between them.
Turn over
Projector Power cord Computer cable
User’s Guide
CD-ROM
Carrying case
Password protect
sticker
Distance from projector to screen (ft.)
29.4(Wide)–39.8(Tele) ft.
(in.)
19.6–26.5
9.7–13.2
7.8–10.5
5.8–7.9
4.8–6.6
2.93.9
3.8–5.2
Epson
®
PowerLite
®
S4
3 Set up the remote control
1 Remove the battery cover.
2 Insert the batteries.
3 Replace the battery cover.
The remote control is ready for use.
Projector
remote control
To play back audio through the projector, you can connect an audio
cable from your video device to the audio ports on the projector.
See the User’s Guide on your CD-ROM for instructions.
NOTE
RCA video cable
(composite
video)
S-Video
cable
Component
video to
VGA cable
Computer
cable
(included)
Audio ports
Batteries