Amana Electric Range Installation Instructions Manual

Download Installation instructions manual of Amana ELECTRIC RANGE Cooktop, Ranges for Free or View it Online on All-Guides.com.

Brand: Amana

Category: Cooktop , Ranges

Type: Installation instructions manual for Amana ELECTRIC RANGE

Pages: 6 (0.56 Mb)

Download Amana ELECTRIC RANGE Installation instructions manual

Amana ELECTRIC RANGE Installation instructions manual - Page 1
1
Amana ELECTRIC RANGE Installation instructions manual - Page 2
2
Amana ELECTRIC RANGE Installation instructions manual - Page 3
3
Amana ELECTRIC RANGE Installation instructions manual - Page 4
4
Amana ELECTRIC RANGE Installation instructions manual - Page 5
5
Amana ELECTRIC RANGE Installation instructions manual - Page 6
6
Installation
Instructions
Electric Range
Keep instructions for future reference. Be sure manual stays with range.
Read entire instruction before beginning installation.
Read Owners Manual for safe installation.
PREPARE TO
INSTALL RANGE
AND INSTALL
ANTI-TIP
BRACKET
Measure cabinet area and prepare
it according to illustrations in
Minimum Clearances to
Combustible Surfaces
and
Range
and Cabinet Dimensions
section in
this manual.
Remove the packing
materials and locate
the anti-tip bracket,
screws and plastic
anchors.
1
3
1
/
2
"
Anti-tip
bracket can
be installed
on either
side of
range.
Anti-tip Bracket Installation
To avoid risk of range tipping, secure
range with a properly installed anti-
tip bracket.
1. Measure and mark 3
1
/2" from
back wall on either right or left
side of cabinet cutout.
2. Place anti-tip bracket 3
1
/2" from
back wall and against the side
cabinet.
If range is not installed
beside cabinet(s), position
range where it will be
installed. Draw a line along
side of range. Remove range
and place anti-tip bracket
with back edge 3
1
/2“ from
back wall and on the line
drawn along side of range.
3. Mark 2 hole locations in anti-tip
bracket, remove bracket and
drill 2 holes.
If drilling into wood, use a
3
/32" drill bit.
If drilling into concrete, use a
3
/16" masonry drill bit and
insert plastic anchors.
4. Secure bracket to floor using
screws supplied.
5. After range is in final position,
remove range storage drawer
or lower panel and confirm anti-
tip bracket is engaged with
range leveling leg.
You'll Need a Few
Things Before You Begin
Important–Save for local electrical inspector’s use.
Wrench
Screw
Drivers
Level
Power Cord
(3-wire or 4-wire)
and Strain Relief
Tape Measure
Drill and DrillBit
3
/
32
" for wood floor
3
/
16
" for concrete floor
3
/
8
" Nut Driver
or Sockets