Amana Undercounter dishwasher Installation Instructions Manual

Download Installation instructions manual of Amana Undercounter dishwasher Dishwasher for Free or View it Online on All-Guides.com.

Brand: Amana

Category: Dishwasher

Type: Installation instructions manual for Amana Undercounter dishwasher

Pages: 6 (0.62 Mb)

Download Amana Undercounter dishwasher Installation instructions manual

Amana Undercounter dishwasher Installation instructions manual - Page 1
1
Amana Undercounter dishwasher Installation instructions manual - Page 2
2
Amana Undercounter dishwasher Installation instructions manual - Page 3
3
Amana Undercounter dishwasher Installation instructions manual - Page 4
4
Amana Undercounter dishwasher Installation instructions manual - Page 5
5
Amana Undercounter dishwasher Installation instructions manual - Page 6
6
Installation
Instructions
Installer–Leave this manual and other literature with owner for future use.
Undercounter Dishwasher
Keep instructions for future reference. Be sure manual stays
with dishwasher. Read entire instruction and Owners
Manual before beginning installation.
You'll Need a Few Tools
Before You Begin
Remove Kickplate
1. Remove two screws at front of
the kickplate assembly.
2. Tilt kickplate forward to remove.
3. Locate water inlet valve behind
kickplate on the bottom left
underside of unit. This valve has
a
3
/8" NPT female fitting
4. Wrap 90° elbow (not included)
with pipe thread tape (or apply
joint compound) and thread into
water inlet valve.
5. Tighten elbow with a wrench,
leaving elbow pointing toward
rear of unit. To prevent
bending of bracket or
breaking of valve, avoid
overtightening.
PREPARE TO
INSTALL
DISHWASHER
AND ROUGH IN
1
Each home installation differs. You
will need additional parts, not
included, to complete installation:
Parts you will need
(not included)
Drain hose clamp, 1
1
/4" diameter
Water supply line or tubing
Elbow, 90° with a
3
/8" National Pipe
Thread (NPT)
Strain Relief Bushing (
3
/4" box
connector)
Wire nuts (2) for 12 to 14 gauge wire
Parts you may need
(not included)
‘Y’ branch tailpiece and connector kit
Air Gap Kit
Fasteners for floor anchoring
Electrical power cord, 12 to 14 gauge
Verify location has the proper drain,
water and electrical outlets to make
the connections. See
Location and
Electrical Requirement Considerations
in this instruction. Also see
Dishwasher, Cabinet, and Supply
Dimensions
in this instruction.
Remove any carpet from area to
provide motor clearance. Floor should
be flat and free of any obstruction.
Do not install dishwasher under a
cooktop. Damage will occur.
water
inlet valve
Screw
Drivers
Level
Tape Measure
Drill and DrillBit
3
/
16
",
1
/
4
",
5
/
16
"
Socket Driver
Duct
Tape
Pipe Thread Tape
Electrical Tape
Open End Wrenches