Amana IC7 Installation And Operating Instructions
Download Installation and operating instructions of Amana IC7 Ice Maker for Free or View it Online on All-Guides.com.
Brand: Amana
Category: Ice Maker
Type: Installation and operating instructions for Amana IC7
Pages: 4 (0.12 Mb)
1
2
3
4
Item Description Part number Quantity
1 Ice maker D7824702 1
2 Ice maker cover 10519801 1
N/S Warning label A3036901 1
N/S Diagnostic label 10834701 1
N/S Label 10549601 2
3 Ice maker arm 10884401 1
4 Lower mounting bracket B8391802 1
5 ½" sheet metal screw M0211017 1
6 Stainless steel clip B5720301 1
7 Water fill tube elbow 10463201 1
8 Ice maker wire harness D7813004 1
9
Ice maker wire harness
clamp
10526701 1
N/S Thermal fuse clip 10319801 1
10 5/8" sheet metal screw M0211018 3
N/S Button plug M0311301 2
11 Water valve 10524606 1
12 Nut and sleeve M0753001 1
13 ¼" plastic tubing B5705325 1
14 Anti-kink spring A1055101 1
N/S Stainless steel insert A3223101 1
N/S Hose clamp M0114003 1
N/S
Compression nut and
sleeve
10244904 1
N/S “P” clamp M0102301 1
15 Plastic clip M0104101 1
16 Installation Instructions 10527024 1
Introduction
!
Recognize this symbol
as a safety precaution
Read entire manual before installing kit. All necessary
tools and materials must be available prior to installation.
Verify all listed parts are included in kit. If parts are
missing, contact source from whom kit was purchased.
• Mechanical experience is required to install kit.
• Depending on installer’s knowledge and skill,
installation can take from 3 to 6 hours.
• If unable to solve a problem during installation,
contact an authorized Amana technician. Locate a
Factory Service Center or independent authorized
Amana technician by calling 1-800-628-5782 inside
U.S.A. and 1-319-622-5511 outside U.S.A. Service is
at owner’s expense.
Safety Instructions
WARNING
!
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before installing kit. After installing kit,
connect power.
CAUTION
!
To avoid property damage, observe the following:
• Confirm water pressure to water valve is at least 20
pounds per square inch.
• Start nuts by hand to avoid cross threading. Finish
tightening nuts using an adjustable wrench. Do not
overtighten.
• Check carefully for water leaks prior to returning
refrigerator to normal location and 24 hours after
connection.
Materials Required
Important
• Before connecting ice maker, contact a plumber to
connect copper tubing to household plumbing in
compliance with local codes and ordinances.
• Amana Appliances recommends using a saddle valve.
Do not use self-piercing valve. Amana Appliances is
not responsible for property damage due to improper
installation or water connection.
1
/4" (6 mm) flexible copper tubing*.
*Length of copper tubing must reach from water supply
connection plus an additional 8' (2 m) for service loop
behind refrigerator. Tubing should be soft instead of rigid
and ends should be free of burrs.
Parts
Use listed part numbers only when ordering replacement
parts. Part numbers are not used in installation
instructions.
7
3
1
2
4
5
8
9
6
14
12
11
13
16
IC7 Ice Maker Kit Installation and Operating Instructions