Fisher & Paykel E372B Quickstart Manual

Download Quick start manual of Fisher & Paykel E402B Control Panel, Freezer for Free or View it Online on All-Guides.com. This version of Fisher & Paykel E402B Manual compatible with such list of devices, as: E402B, E522B, RF522W, RF540A, RF610A

Fisher & Paykel E402B Quick start manual - Page 1
1
Fisher & Paykel E402B Quick start manual - Page 2
2
Introduction
Thank you for buying a Fisher & Paykel ActiveSmart™ refrigerator. This is a Quickstart Guide to help you install and use your refrigerator. For more
detailed information please refer to the User Guide supplied with your product or visit www.fisherpaykel.eu.
Important safety precautions
All models
WARNING! – When using your refrigerator, follow basic precautions, including the following:
Read all instructions before using the refrigerator.
Danger
This appliance is not intended for use by persons (including children under the age of 8) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance and the hazards involved by a person
responsible for their safety.
Cleaning and user maintenance shall not be made by children without supervision.
Young children should be supervised to ensure they do not play with the appliance.
Risk of child entrapment. Before you throw away your old refrigerator:
– Take off the doors
– Leave the shelves in place so that children may not easily climb inside.
The manufacturer’s installation instructions for product and cabinetry ventilation must be followed when
installing the appliance.
Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
Do not use mechanical devices or other means to accelerate the defrosting process, other than those
recommended by the manufacturer.
Do not damage the refrigerant circuit.
Refer to the stability bracket and leaflet supplied to avoid hazard due to instability of the appliance.
R600a
This refrigerator may contain the flammable refrigerant isobutane.
Electrical
This appliance must be properly installed in accordance with the installation instructions before it is used.
Never unplug your refrigerator by pulling on the power cord.
Always grip the plug firmly and pull straight out from the outlet.
Do not plug in any other appliance at the same power point as your refrigerator or use extension cords or
double adapters.
Repair or replace immediately all electric service cords that have become frayed or otherwise damaged.
Do not use a cord that shows cracks or abrasion along its length or at either the plug or appliance end.
If the power supply cord is damaged, it must only be replaced by your Fisher & Paykel Appliances
Authorised Service Centre because special purpose tools are required.
When moving your appliance away from the wall, be careful not to roll over or damage the power cord.
Unplug your refrigerator before cleaning or replacing the lightbulb.
Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of
the type recommended by the manufacturer.
Storing food and drinks
DO NOT store explosive substances such as aerosol cans with a flammable propellant in this appliance.
Never store volatile or flammable materials in your refrigerator as they may explode.
ActiveSmart™ refrigerators
Quickstart guide
Ice & Water and Non-Ice & Water
E372B, E402B, E406B, E522B, RF522W, RF522A & RF540A/RF610A models
EU
Never freeze carbonated drinks or liquids in glass containers. Liquid expands during freezing, which may
cause the container to explode.
Do not consume food if it is too cold. Food removed from the freezer compartment may be cold enough to
cause damage when brought into contact with bare skin, eg frozen ice cubes.
Cleaning
The exterior and interior of your refrigerator should be regularly cleaned. Only clean it with a solution of
liquid dishwashing detergent dissolved in warm water. Do not use any other cleaning products as they can
contain solvents which cause plastic components of your refrigerator to crack.
Ice & water models only
DO NOT use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
WARNING – connect to potable water supply only.
DO NOT install on line pressure above 827 kPa (119 psi) or below 150 kPa (22 psi).
DO NOT use on hot water supply (38°C [100°F max.]).
DO NOT cut any length of tube shorter than 200 mm (8”).
DO NOT install near electrical wires or water pipes that will be in the path of drilling when selecting the
location of filter system.
DO NOT mount filter in such a position so that it will be struck by other items, such as wastebaskets, etc.
DO NOT install the filter or any water tubing in direct sunlight as prolonged exposure to light can weaken
plastic components.
DO NOT install in a location that is susceptible to freezing temperatures as damage to the housing could occur.
DO NOT screw filter to fridge.
DO NOT install the filter or any water tubing in high temperature areas eg in a ceiling cavity.
AVOID contamination of pipes during installation.
DO NOT use copper tubing. The plastic tubing supplied should always be used.
DO NOT continuously dispense water for longer than 2 minutes.
1
InstallatIon InstructIons
1a Power
The appliance must be installed so the plug is accessible.
To ensure that the appliance is not accidentally switched off, connect
your refrigerator to its own power point.
For power requirements, refer to the information on the serial plate
located at the front bottom right-hand side of the refrigerator when
the door is open.
It is essential that the appliance be properly grounded (earthed).
If your refrigerator is turned off for any reason, wait 10 minutes before
turning it back on.
1b Location
Your refrigerator should not be located in direct sunlight or next to any
heat generating appliance such as a cooktop, oven or dishwasher.
If your product is an Ice & Water model, a water supply must be available
to connect to the refrigerator. See panel 4 for installation instructions.
1c Ventilation and installation
When installing your refrigerator, ensure you allow adequate
ventilation around the cabinet. The following dimensions are the
minimum air clearances:
Both sides = 20 mm Rear = 30 mm Top = 50 mm
Ensure you allow sufficient space to open your refrigerator and freezer
door adequately.
The table and diagrams in the Installation instructions in the User
Guide, details all the necessary cabinet dimensions.
1d Ice and water installation
Important!
It is imperative the pressure reducing valve (PRV) is fitted prior to the
filter. This valve ensures the water will not flow back into the mains
from the refrigerator water system. If the PRV is not fitted to the
connection line your Ice & Water refrigerator features may not function
in some circumstances.
Water connection should be installed by an authorised plumber or
authorised Fisher & Paykel service person. Instructions are intended
only for the professional installer, please follow to ensure appliance
operates correctly.
The new tubings supplied with the machine are to be used, old tubings
should not be used.
1 23
Fig.1 Connection to water supply
1
Ensure that refrigerator is not plugged into a power supply.
2
Locate isolation tap for water connection – cold water feed only
(dishwasher or sink mixer taps). Tee and tap fitting is not supplied.
3
Connect the 200 mm blue tubing to the outlet of the PRV (blue collet)
and the inlet connection of the water filter cartridge as shown in Fig.1
Point 1. Gently pull on both ends to ensure it is locked.