• Home
• Brands
• Tube Works Manuals
• Tube Works 910
• Tube Works 910 User Manual

Tube Works 910 User Manual

Download Operation & user’s manual of Tube Works 910 Amplifier for Free or View it Online on All-Guides.com.

1

2

WARRANTY AND OWNER REGISTRATION

Your TUBE DRIVER is warranted for a period of THREE

FULL YEARS against defects to the original, registered

owner provided he/she has returned a completely filled-

out OWNER'S REGISTRATION CARD.

This warranty covers parts and labor only; shipping

charges remain the sole responsibility of the owner.

Damage due to modification or abuse is excluded from

this warranty. Before returning any unit for service, a RE-

TURNED MERCHANDISE AUTHORIZATION NUMBER

(R.M.A.#) must be obtained.

Manufacturer is not responsible for consequential or in-

consequential damages resulting from any application or

use of this product. Manufacturer and sales agents as-

sume no liability or responsibility for safety or injury relat-

ing to the use of TUBE DRIVER, and user agrees to hold

manufacturer and designer harmless in this regard. This

is the full extent of the warranty; no other warranties im-

plied or intended.

For service and return authorization contact:

7811 E. Pierce Street

Scottsdale, AZ 85257

Ph: 480-941-0705 Fax: 480-946-2412

910 TUBE DRIVER

You’ve just purchased the vintage tube overdrive pedal

that started it all—TUBE DRIVER! Please take a mo-

ment to look over this brochure, and be sure to send in

the owner’s registration and your comments.

Again from the leading innovator of the modern tube

overdrive, B.K. Butler, a major break-through in the

classic 12AX7A tube sound. The ability of the Tube

Driver to be powered from a common 9-volt battery

eliminator puts this pedal into your hands for under

$100.

Your new Tube Driver pedal operates from the same

type of battery eliminator as most of your battery-

operated effects (9-volt DC 200mA Min.), and it’s small

enough to fit in your pedal case.

The best thing about your Tube Driver is that instead of

bogus, cheap, solid state overdrive, you now have the

fat, warm, searing Real Tube sound.

OPERATION

Plug in a battery eliminator (9-volt DC 200mA Min.)

and allow the tube to “warm up” for about 15 seconds.

Then plug your guitar into the “In” jack, and your amp

to the “Out”. Set the Tube Driver, EQ and Level Out

controls to where your ears feel good, and you’re set.

(The red LED shows the Tube Driver is active.)