American Standard Personal Shower System 1660.100 Series Installation Instructions

Download Installation instructions of American Standard Personal Shower System 1660.100 Series Plumbing Product for Free or View it Online on All-Guides.com.

American Standard Personal Shower System 1660.100 Series Installation instructions - Page 1
1
TM
AMARILIS™
DELUXE SHOWERHEAD
BODY SIDE SPRAY
30449
All product names listed herein are trademarks of American Standard Inc.
American Standard Inc. 1990
C
Printed in West Germany
RECOMMENDED INSTALLATION FOR
MULTIPLE BODY SIDE SPRAYS:
Installation Instructions for:
ROUGHING-IN DIMENSIONS
Personal Shower System
1660.100 SERIES
1660.120 SERIES
1/2"
MAX.
6-1/2"
4-3/4"
FINISHED
WALL
FINISHED
WALL
OPTIONAL TO
FINISHED FLOOR
USUALLY 65" TO 78".
FOR USE WITH BODY
SIDE SPRAYS 72" TO 78"
IS RECOMMENDED.
SEE
RECOMMENDED
INSTALLATION
BELOW
4"
TO SHOWERHEAD
3 HANDLE
B/S VALVE
16"
16"
TWO-WAY
DIVERTER
VALVE
TUB SPOUT
24"
1/2" S.P.S.
32" OPTIONAL
TO FINISHED
FLOOR
DELUXE SHOWERHEAD
BODY SIDE SPRAY
For maximum flow, use Amarilis 3-Handle
Bath/Shower Valve 8030 or 8031 Series.
Connect multiple body side sprays to spout
outlet of valve.
Provide two-way diverter valve for addition of
tub spout.
Connect deluxe showerhead to shower outlet
of valve.
1 ROUGHING-IN
Prepare shower connection nipples per roughing-in 
dimensions. See diagram for recommended 2 and 3 
BODY SIDE SPRAY installation.
Cap nipples, turn on water supplies and check for leaks.
2 SHOWERHEAD INSTALLATION
Slide ESCUTCHEON forward and compress
BELLOWS to expose supply connectors.
Use adjustable wrench to install SHOWERHEAD.
Turn on water supplies and check for leaks.
Push ESCUTCHEON back until seated flush against
wall.
3 SERVICE
To increase swivel tension:
Compress BELLOWS towards rear to expose ball joint.
Wrench tighten COUPLING NUT to increase tension.
The FLOW REGULATOR may accumulate debris causing
reduced water flow. To clean, remove SHOWERHEAD,
then:
Remove ESCUTCHEON and BELLOWS.
Unscrew SUPPLY CONNECTOR to remove FLOW
REGULATOR.
Clean FLOW REGULATOR, re-assemble and install
SHOWERHEAD.
ESCUTCHEON
AND
BELLOWS
SUPPLY
CONNECTOR
FLOW
REGULATOR
COUPLING
NUT
Each installed BODY SIDE SPRAY requires
2.5 GPM for an adequate spray flow.
1/2"
MAX.
1-1/2"
1-1/2"
- 2 SPRAY - 3 SPRAY
28" OPTIONAL
TO FINISHED
FLOOR