TO BE REMOVED BY THE CUSTOMER AFTER INSTALLATION JS COMPLETE. (Turntootherside for Spanishversion,)
f
[] INSTALLATION CHECKOFF LiST
Doors
[] Handbs are secure and tight
[] Door seaUscompbteUy to cabinet on aHsides
[] Doors are bveUacross the top
Leveling
[] Refrigerator is bveL side to side and tilted 1/4" (6mm) front to back
[] Toe gdHe is properUyattached to refrigerator
[] Cabinet is setting solid on aHcorners
[]
[]
ice Maker
ElectricaJ Power
House power turned on
[] House water suppUy connected to refrigerator
[] Water & power couplings connected at door
[] No water leaks present at all connections - recheck in 24 hours
[] Ice Maker is turned ON,
[] Ice & Water Dispenser operates correctly
[] Front filter must be flush with filter housing (some models)
FinaJ Checks
[] Shipping material removed
[] Fresh Food and Freezer controls set
[] Crisper Humidity controls set
[] Registration Card sent in
1
HAND TRUCKING
* Load refrigerator from side of cabinet
only.
o Do not run retaining straps over
handles.
Do not over-tighten retaining straps.
Never use refrigerator handles to
move the refrigerator.
Remove tape from doors only after
unit is in place.
f
INSTALLATION CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical
connections:
Sides & Top.......... 3/8"
Back ....................... 1"
NOTE: if you are installing your refrigerator beside a wall,
leave 1/2" minimum between hinges and wall to allow for
the door to swing open.
Ensure icemakertoturned ON.Check to see thatthe ice & Water
Dispenser is operating correctly. (See Automatic ice & Water
k Dispenser Features in Use & CareManuaL) j
SHIPPING MATERIAL
I PIECE OF TAPE --
WIRE TreES and/or TAPE-
(On all wire baskets)
_i!'i{_N!;!_!i'it!
--! PmECE OF TAPE OR
2 BLUE SHHPPING CUPS
--SHELF SPACER WHTH TOE GRILLE
--! PIECE OF TAPE
--3 PIECES OF TAPE
--"4 PIECE OF TAPE
==='3 PIECES OF TAPE
_3 PmECEB OF TAPE
.. Remove Shipping material (Features may vary per model.) ._
Tools You Will Need:
............ WATERSUP
Connect water supply - check for water leaks, Turn icemaker OFF
if water suppJy is not connected immediateJy. Connecting to a
reverse osmosis system is not recommended.
J
LEVELING AND ADJUSTING _:'_
All four corners of refrigerator must rest firmly on a solid
floor. Your refrigerator has adjustable rollers to help level it
and to adjust the doors. _-_'_
To level cabinet or change door height: _ RAISE H
1. Remove toe grille.
DOOR
][
2. Use a screwdriver, 3/8"wrench, or nutdriver to adjust the
rollers.To raise cabinet or door, turn screw clockwise.To
lower cabinet or door, turn screw counterclockwise.
LOWER _,
DOOR
if you need to remove the doors to get your refrigerator in the house, please see
Door Remow/Instructions in your Use & Care Manual.
When
changing
control
settings, wait
24 hours before
making additional
adjustments.
_' See"Norma{ Operating Sights & Sounds" in the Use & Care
Manualso you understand the sounds you may hear once
your refrigerator is running,
q Please read entire Use & Care Manualto become aware of
important safety instructions and to become familiar with your
new refrigerator,
x' Send in Registration card to register your refrigerator.
_J Congratulations! You are ready to enjoy your new refrigerator.
IF YOU ARE DISSATISFIED WITH THE INSTALLATION OF YOUR REFRIGERATOR, PLEASE CALL THE STORE YOU PURCHASED IT FROM. P/N:241540500
