AMX Solecis AVB-DA-RGBHV-ST-0102 Installation Manual

Download Installation manual of AMX Solecis AVB-DA-RGBHV-ST-0102 Amplifier for Free or View it Online on All-Guides.com.

Brand: AMX

Category: Amplifier

Type: Installation manual for AMX Solecis AVB-DA-RGBHV-ST-0102

Pages: 1 (0.16 Mb)

Download AMX Solecis AVB-DA-RGBHV-ST-0102 Installation manual

AMX Solecis AVB-DA-RGBHV-ST-0102 Installation manual - Page 1
1
Installation Guide
Solecis AVB-DA-RGBHV-ST-0102
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
6/09
©2009 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-1340-1101-02 REV: E
Overview
The Solecis AVB-DA-RGBHV-ST-0102 1x2 RGBHV HD-15, Stereo Distribution
Amplifier (FG1340-1101-02) is a high-resolution wideband PC splitter with
exceptional characteristics and features that are second to none.
With an RGB video bandwidth in excess of 350Mhz (-3dB), the
AVB-DA-RGBHV-ST-0102 is the perfect choice for a variety of presentation
applications. The buffered input provides for a local monitor loop through and
main output for onward connection to monitors, projectors and plasma displays.
The main output features 75 ohm drive for connection to long cable runs and
TTL sync restore for total compatibility.
Product Specifications
Safety Instructions
Please read these instructions before using your AMX Solecis device. Failure to
comply with these instructions could result in fire, electrical shock, personal injury,
death, or damage to the equipment.
Liquid Spills
Do not set drinks on top of the unit or immerse the unit in liquid.
Do Not Disassemble
This device contains no user serviceable parts. All servicing must be performed by a
qualified service technician.
For Safety Reasons
Do not place the unit on an unstable surface.
Do not use near water or sources of heat.
Use only recommended attachments.
Use the type of power supply as specified.
Unplug the power to the unit and refer servicing to qualified personnel under the
following conditions:
If liquid has been spilled or the unit has been exposed to rain or water.
If it does not operate normally when the operating instructions are followed or if
it exhibits a distinct change in performance indicating a need for service.
If the unit has been dropped or the cabinet damaged.
Connections
Connect the RGBHV and Audio sources to the Input sockets on the front panel
of the unit.
The RGB inputs are 75 ohm terminated and the audio input 47Kohm termi-
nated. The video outputs are fully 75 ohm driven and the audio balanced.
For unbalanced systems use the + and Gnd terminals.
Note: It is imperative that the input sources are fully compatible with the display
and sound devices.
The unit may now be powered.
Power / Video Indication (“Active” LED)
When the unit is powered without the RGBHV input connected, the Active
indicator will be Red.
When a signal source is applied, the indicator will turn Green.
Video Pin Connections
FIG. 2 provides the pin layout for the HD-15 connectors:
The pin configuration for the HD-15 (video) connector are as follows:
FIG. 1 Solecis AVB-DA-RGBHV-ST-0102
AVB-DA-RGBHV-ST-0102 Specifications
RGB Input (HD-15)
Number: 1
Level: Analog
Max Level: 1V p-p
Impedance: 75 ohm
Sync Input
Type: Analog or TTL
Impedance: 470 ohm
RGB Video Bandwidth: 300MHz -3dB
RGB Return Loss: -45dB@10MHz, -27dB@100MHz
Sync Processing: None
RGB Outputs (HD-15)
Number: 2
Level: Analog
Gain: Unity
Impedance: 75 ohm
Sync Output
Level: TTL
Gain: TTL restore
Impedance: 75 ohm
Audio: Balanced/Unbalanced audio via 3.5mm stereo socket to
phoenix
(rear)
(front)
Audio IN
Audio OUT
Video OUT
Video IN
Monitor IN
Activity LED
green = signal source present
red = unit powered but not
connected to RGBHV source
AVB-DA-RGBHV-ST-0102 Specifications (Cont.)
Power
Input Voltage: 9-12VDC
Power Consumption: 3W
Heat Dissipation: 10.2 BTU/hr
Dimensions (HWD): 1.66” x 5.85” x 4.25”
42.2mm x 148.6mm x 108.0mm
Weight: 1.5 lbs. (0.68kg)
Included Accessories: PS2.8 power supply (FG423-11)
Certifications: CE
FCC class B, part 15
RoHS/WEEE compliant
FIG. 2
RGBHV HD-15 connector
1 - RED 9 - n/c
2 - GREEN 10 - SYNC GROUND
3 - BLUE 11 - n/c
4 - n/c 12 - n/c
5 - n/c 13 - H SYNC
6 - RED GROUND 14 - V SYNC
7 - GREEN GROUND 15 - n/c
8 - BLUE GROUND
12345
678910
1112131415