Quantum DLT 2000 User Manual

Download Operation & user’s manual of Quantum DLT 7000 Storage, Tape Deck for Free or View it Online on All-Guides.com. This version of Quantum DLT 7000 Manual compatible with such list of devices, as: DLT 7000, DLT 2500, DLT 2700, DLT 4500, DLT 8000

Quantum DLT 7000 Operation & user’s manual - Page 1
1
Quantum DLT 7000 Operation & user’s manual - Page 2
2
Quantum Corporation DLTtape Application Note
_____________________________________________________________________________________________
Copyright 1999-2001 Quantum Corporation or its subsidiaries or affiliates. All rights reserved
DLTtape Installation on HP® 9000 Series 700 System
HP-UX® 9.X
This application note is to be used only as a guideline for the titled subject. The user assumes all
responsibility for understanding the interrelationships of this information with other affected software or
system products. Quantum Corporation provides this information as a service only, and assumes no
responsibility for any damages, which could result from the use of this information.
The information in this application note is subject to change without notice and is not to be construed as a
commitment by Quantum Corporation. Quantum Corporation assumes no responsibility for any errors that
may appear in this document.
NOTE: The information in this document pertains to DLT2000, DLT2000XT, DLT4000, DLT7000
or DLT8000 cartridge tape drive or the DLT2500, DLT2500XT, DLT2700, DLT2700XT,
DLT4500 or DLT4700 tape mini-library that you are installing. DLT drives cannot be used with HP's
fbackup/frecover utility on this system.
The following section describes the installation and configuration of a DLT tape peripheral on an HP 9000
Series 700 system running HP-UX 9.X. The DLT controller firmware must have OEM-1 controller
firmware installed.
Installation
The system must have the appropriate SCSI interface for DLT drive to attach to, i.e., a SCSI single-ended
DLT drive can be attached only to a SCSI single-ended interface. The same is true for SCSI differential
attachment. The hardware attachment simply requires the DLT tape peripheral to be attached to the
interface while the system is powered down. After the DLT tape peripheral has been attached, you will
need to perform certain system operations that will allow DLT device system recognition.
Perform the installation as follows:
Shutdown the system and remove AC power from the system. Install the DLTtape peripheral and
connect it to the SCSI controller. Depending on the DLT tape peripheral you are installing, refer to one of
the following manuals for switch and jumper settings and SCSI bus termination:
DLT2000/DLT2700 product manual (order number 81-109132)
DLT2500 owner's manual (order number 81-109374)
DLT2000XT/DLT2500XT/DLT2700XT product manual (order number 81-109253)
DLT4000/DLT4500/DLT4700 product manual (order number 81-106336)
DLT7000 Tape Drive product manual (order number 81-60000)
DLT8000 Tape Drive product manual (order number 81-60118)
Set the DLT SCSI device address to an unassigned SCSI ID. Power up the system. During the power-
up, the process allows you to stop the sequence by pressing the ESC key. By doing so, you can verify
drive attachment by issuing a search for boot device selection. This will display all attached SCSI devices
including the DLT tape drive. The boot process can continue by selecting the appropriate boot disk.
Log on as root and change directory to /dev/rmt