Sears FTK-127 Instructions
Download Installation instructions of Sears FTK-127 Kitchen Appliance Accessories for Free or View it Online on All-Guides.com.
Brand: Sears
Category: Kitchen Appliance Accessories
Type: Installation instructions
Model: Sears FTK-127 , Sears FTK-130
Pages: 4 (0.79 Mb)
1
2
3
4
FTK-127i130 Buitt-in Trim Kit lnstaHtation instructions
For use with the following microwave oven ACM2160A and UMC5200AA
Proper installation is the instailer's responsibility!
Write the model & sedal numbers on the owner's manual,
The model number label is }ocated on the oven front=
UL Listed-For use over electric heat source
models
(Wail Ovens)
27": ACES2730, AOCS2740,
MEW5527DD, MEW6527DD
30": ACES3030, AOCS3040,
MEW5530DD, MEW6530DD,
AEW3530DD, AEW4530DD,
JJW8130DD, JJW9130DD
WARNING I
To avoid risk of electrical shock, personal injury, or
death, disconnect power to wall outlet before beginning
installation.
Parts, Tools, and Materials
The following parts are supptied with the oven:
Trim Frame (1)
Side Duct (1)
u o IS
Bottom Duct (1)
Template (1)
Upper Duct (1)
1" Screws
(4 required, 2 extra)
1/2" Screws
(11 required, 2 extra)
Bottom Bracket (1) Anti-Tip Bracket (1)
Too_s required to perform installation:
Phillips Screwdriver
Saw (Electric or Hand)
Drill with 1/16"and %4" drill bits (Electric or Hand)
Tape Measure
Pencil
Framing Square
Level
Shipping Weight
Approximate shipping weight is 16 Ibs=
Cutout Dimensions
Dimensions
Heiqht
Width
Depth (min.)
27"
16 3/4"
25 1/2"
23 3/4"
30"
16 3/4"
25 1/2"
23 3/4"
ht
Electric Heat Source Model
I A WARNING
To avoid risk of electrical shock, personal injury, or
death:
, Before drilling into the wall, note where electrical
outlets are and where electrical wire might be
concealed behind the wal!, YOU COULD GET AN
ELECTRICAL SHOCK if you contact electrical wire
with the drill bit.
o Locate and disconnect the power to any electrical
circuits that could be affected by installing this oven.
IF YOU DO NOT DISCONNECT THE POWER, YOU
COULD GET AN ELECTRICAL SHOCK.
i AlL CAUTION ]
To avoid personal injury, wear gloves when handling the
metal parts. Parts are sharp and can cause cuts and
abrasions.