Radio Shack Self-Stick Door/Window Alarm Owners Manual

Download Owner's manual of Radio Shack Self-Stick Door/Window Alarm Carbon Monoxide Alarm for Free or View it Online on All-Guides.com.

Radio Shack Self-Stick Door/Window Alarm Owner's manual - Page 1
1
Radio Shack Self-Stick Door/Window Alarm Owner's manual - Page 2
2
OWNER’S MANUAL — Please read before using this equipment.
©
2000 Tandy Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by Tandy Corporation.
Self-Stick Door/Window Alarm
Your RadioShack Self-Stick Door/Window Alarm is a
convenient and easy-to-use security device. You
can easily install the alarm on almost any smooth
door surface or glass window. If the alarm senses an
abrupt shock or vibration, it sounds a 120-dB alarm
to warn you and scare off possible intruders.
Its features include:
Selectable Sensitivity Switch — lets you set the
alarm’s sensitivity higher or lower.
Red Warning Label — can be seen through window
to show that your home is protected.
Automatic Reset — automatically reset the alarm in
about 30 seconds after the alarm is activated.
Intruder Memory Indicator — warns you that the
alarm has been activated.
PREPARATION
Installing the Battery
The alarm requires a 9V battery for power (not sup-
plied, available at your local RadioShack store).
Caution: Use only a fresh battery of the required
size and recommended type.
Follow these steps to install the battery:
1. Use a Philips screwdriver to loosen the screw in
the battery compartment and slide off the cover.
2. Snap a 9V battery into the connector in the bat-
tery compartment and place the battery in the
compartment.
3. Replace the cover and secure it with the screw.
Warning: Dispose of old batteries promptly and
properly. Do not burn or bury them.
Caution: If you do not plan to use the alarm for a
month or more, remove the battery. Batteries can
leak chemicals that can destroy electronic parts.
Note: When the green low battery indicator flashes,
replace the battery.
Installing the Alarm
Choose a smooth, clean mounting surface, then
peel off the protective film on the back of the alarm
and firmly press the alarm against the surface.
OPERATION
Warning: The alarm is very loud. Prolonged expo-
sure to the siren in an enclosed area may cause per-
manent hearing impairment or loss.
1. To turn on the alarm, slide the cover at the upper
front of the alarm upward, then turn
ON OFF
to
ON
. The red indicator flashes once.
2. Select the alarm’s sensitivity by sliding
HI/LOW
to
HI
or
LOW
. When the alarm senses an abrupt
shock or vibration, it sounds a 120-dB alarm for
about 30 seconds. The red indicator lights and
remains lit to warn you that the alarm has been
activated.
Notes:
If the alarm is triggered again within two min-
utes of the first alarm and while the intruder
light is still on, the subsequent alarms may be
shorter than 30 seconds.
To reset the intruder memory indicator, simply
turn alarm off, then on.
CARE
To enjoy your RadioShack Self-Stick Door/Window
Alarm for a long time:
Keep the alarm dry. If it gets wet, wipe it dry
immediately.
Use and store the alarm only in normal tempera-
ture environments.
Handle the alarm gently and carefully. Do not
drop it.
Keep the alarm away from dust and dirt.
Wipe the alarm with a damp cloth occasionally
to keep it looking new.
49-407.fm Page 1 Friday, May 26, 2000 2:26 PM