• Home
• Brands
• Radio Shack Manuals
• Radio Shack 16-3011
• Radio Shack 16-3011 User Manual

Radio Shack 16-3011 User Manual

Download Operation & user’s manual of Radio Shack 16-3011 Flat Panel TV for Free or View it Online on All-Guides.com.

1

2

2.5” TFT LCD TV

16-3011

BATTERY POWER

Your TV requires four AAA batteries (not supplied).

You may purchase alkaline batteries from your local

RadioShack store.

1. Slide off the battery compartment cover.

2. Insert the batteries into the compartment

as indicated by the polarity symbols (+ and –)

marked inside.

3. Replace the cover.

Notes:

• The TV can operate for about 2 hours (3.5 for audio only mode) with alkaline

batteries. When the sound level lowers or the picture becomes unstable, replace the

batteries.

• The TV’s internal batteries automatically disconnect when you connect an adapter.

AC POWER

You can power the TV using a regulated 6V AC adapter of at

least 400 mA, and a size B Adaptaplug™ adapter (neither

supplied). Both are available at your local RadioShack store.

Set the adapter’s voltage switch to 6V. Insert the Adaptaplug into

the adapter’s cord, aligning + with TIP. Plug the Adaptaplug’s

barrel plug into the TV’s

DC IN 6V jack. Then, plug the other end

of the AC adapter cord into a standard AC outlet.

Note: The adapter might become warm after extended periods

of use.

USING VEHICLE BATTERY POWER

You can power the TV from a vehicle’s 12V power source (such as a cigarette-lighter

socket) using a 6V, 400-mA DC adapter and a size B Adaptaplug™ adapter (neither

supplied).

Set the adapter’s voltage switch to 6V. Insert the Adaptaplug into the adapter’s cord,

aligning + with TIP. Plug the Adaptaplug’s barrel plug into the TV’s

DC IN 6V jack. Unplug

the vehicle’s cigarette lighter and plug the large end of the DC adapter cord into the

cigarette-lighter socket.

Note: If the TV does not operate properly when you use DC power, be sure the cigarette-

lighter socket is clean and that the adapter’s plug is properly connected to the socket.

1. Extend the rod antenna and slide

UHF/VHF/OFF to VHF or UHF. The TV starts scanning and

stops at the next active channel in the selected band.

2. Press

TUNING to tune to a different channel. The tuning line on the screen aligns with

the selected channel number below the screen.

3. To adjust the volume,

rotate VOLUME located on the right side of the TV.

4. To adjust the picture to the desired brightness, rotate

BRIGHT located on the right side of the

TV. The brightness also changes with the screen’s angle.

5. To save battery power, turn off the display and listen to audio only by setting

TV/SOUND to

SOUND.

BACKLIGHT

In low temperatures, the TV screen takes a few seconds to light, or it might be slightly red in color.

This is not a malfunction. Normal operation resumes after a few seconds.

USING AN EARPHONE

For private listening, you can connect an optional earphone with a

1

/8-inch plug to the EAR jack.

This automatically mutes the built-in speaker.

Cautions:

•Set

VOLUME to the lowest setting before you begin listening. Then adjust the volume to a comfortable level.

• Do not use an earphone when operating a vehicle or riding a bicycle. This can cause a traffic hazard and can be illegal in

some areas.

USING THE TV AS A MONITOR

You can play back the signal from an audio/video component connected to your TV’s AUDIO/VIDEO jack. You will need a

Y-adapter cable (not supplied), available at your local RadioShack store. Connect the cable’s red plug to the component’s video

output jack, and its white plug to the component’s audio output jack. Then, plug the cable’s mini plug into the TV’s

AUDIO/VIDEO

jack.

Note: Connecting an audio/video component disables the TV’s antenna.

Power

Using Your TV

Volume - Turn the dial to

adjust the volume level.

Bright - Turn dial to adjust

the brightness level.

Stand - Use the stand to lean

the TV against flat surfaces.

Flat LCD - makes the TV more

compact and uses less power

than a standard picture tube.

TV/Sound — lets you listen to

audio only when TV reception

is poor, or to conserve battery

Ear Jack - Lets you enjoy

private listening with an

optional earphone.

DC IN 6V Jack

UHF/VHF/OFF

AUDIO/VIDEO

EAR Jack

BRIGHT

VOLUME

TV/SOUND

Alkaline Batteries

6V AC to DC Adapter

6V Vehicle DC Adapter

EXT. ANT. Jack - Lets you

connect an external antenna

for optimum reception in

weak signal areas.

Tuning Ý /Þ - Press the

control to adjust the TV to the

desired channel.

Optional Accessories

Earphones

Size B Adaptaplug

Rod Antenna — provides

adequate reception in most

metropolitan areas