• Home
• Brands
• Rane Manuals
• Rane TTM 54I
• RANE TTM 54I Operators Manual

RANE TTM 54I Operators Manual

Download Operator's manual of Rane TTM 54I DJ Equipment, Mixer for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

Manual-1

TTM 54i

PERFORMANCE MIXER

OPERATORS MANUAL

Quick Start

For experienced turntablists, ninety percent of

the operation of the TTM 54i Performance Mixer

is obvious — however, the TTM 54i also has many

unique features. ese new features will be mastered more

quickly if you read the entire manual. Right! We know some

of you can’t resist jumping right in, so please read at least this

portion of the manual. It will help you get a good start.

• GAIN TRIM: ese controls are intended to set the signal level

before the Crossfader. Always set the GAIN TRIM controls to

indicate an average signal level of +4 on the meter with the Program

Faders set to maximum. Never use the GAIN TRIM controls to set the

output level. Always use the MASTER LEVEL control to set the output

level. is is a very simple thing, yet makes a huge difference in the performance

of your mixer.

• EFFECTS: e assignable effects loop allows insertion of a stereo effects processor into:

• Pre-Program Fader PGM 1....... Engage PGM 1 EFFECTS only.

• Pre-Program Fader PGM 2....... Engage PGM 2 EFFECTS only.

• Post-Crossfader MASTER........ Engage both PGM 1 and PGM 2 EFFECTS switches.

• Read sections  and  for more information.

• PHONES: e headphone output of the TTM 54i is a high power output stage (unlike most you have used before). ere are

some notable differences…

• e headphone output of the TTM 54i delivers very high volume into your headphones.

• To avoid pain, never put headphones on your head and then plug them in.

• Always start with the PHONES LEVEL turned down and then turn it up to the desired level.

• Because of the high current and low output impedance, never short one side to ground or short left and right together as is

possible with mono cup headphones. Note: Low power headphone stages typically use large resistors on their outputs, which

allow shorting, but prevent high power. e TTM 54i gives you high power but does not allow shorting.

• MIC LEVEL: For best performance, keep this control at 0 when not in use.

• For instructions on rotating Phono/Line switches to the desired location, see page Manual-6.

• Do not spray cleaner or lubricant into the front of the Program Faders or Crossfader. e fluid will just run out the bottom of

the unit. Never use unapproved cleaner or lubricants such as skateboard wheel lube, as corrosive damage may result, voiding the

warranty. See page Manual-6 for cleaning and replacement instructions and cleaner recommendations.

• Never connect anything except an RS 1 Rane AC power supply to the thing that looks like a telephone jack on the rear. is

is an 18 VAC center-tapped power unit. Consult the Rane factory for replacement or substitution.

• WEAR PARTS: is product contains the following wear parts subject to the ninety (90) day warranty period described on page

Warranty-1: FT 45 Crossfader & Channel Fader Assembly(3); ST 2 Phono/Line Switch Assembly (2).