• Home
• Brands
• REVELL Manuals
• REVELL Ultima Gem
• Revel Ultima Gem Specifications

Revel Ultima Gem Specifications

Download Specifications of REVELL Ultima Gem Speakers for Free or View it Online on All-Guides.com.

1

®

Wall-Mount Template

CABINET

BRACKET

WALL

BRACKET

Step 10: The loudspeaker can now be mounted onto the wall bracket.

Slide the loudspeaker onto the bracket from above, as shown. Make sure

the brackets are firmly mated before releasing the loudspeaker.

WALL-MOUNTING INSTRUCTIONS

The Ultima Gem®2 loudspeaker can be mounted to a wall or the optional pedestal.

The following instructions provide detailed information regarding how to mount the

loudspeaker on a wall in your listening room. Before beginning the installation, consider the

best position to mount the loudspeaker for optimum performance. Refer to the Installation

Considerations section for guidance on the best placement for the loudspeaker.

Note: The Gem2 Loudspeaker is NOT designed to mount on a ceiling.

Caution

Before installation, consult a qualified installer or contractor familiar with the safety

requirements of mounting heavy objects. The customer is responsible for proper mounting

of the loudspeaker. Harman Specialty Group assumes no responsibility for proper selection

and installation of hardware or for any personal injuries or product damages resulting from

improper installation or a fallen loudspeaker.

Step 1: Determine the approximate location on the wall where the loudspeaker will be

mounted and find the nearest pair of wall studs. Use a stud finder if necessary.

Note: For safety purposes, the loudspeaker must be centered on a wall stud when mounted.

Step 2: Retrieve the wall-mount template, found in the accessory bag that was shipped

with the loudspeaker.

Step 3: Tape the template to the wall, centering the drill holes over a wall stud. Ensure that

the bracket distance is at least 15.5” (394 mm) from the edge of the ceiling.

Note: The two vertical holes in the center of the bracket template are the holes that are used

for wall-mounting the loudspeaker to the stud.

Step 4: Use a level to verify that the bracket tilt is zero and then drill two 1/16” (1.58 mm)

diameter pilot holes.

Step 5: Retrieve the wall bracket from the plastic accessories bag that shipped

with the loudspeaker.

Step 6: Remove the template from the wall.

Step 7: Place the wall bracket flat against the wall so that the drilled holes in the wall line up

with the wall bracket holes. Be sure to position the bracket so that the out-thrust tabs are on the

bottom end. These are the stops that keep the speaker from sliding off the bracket.

Step 8: Secure the wall bracket in place with two screws. The minimum required size of the

screws is #10 (up to a maximum of 1/4”) x 2-1/2” long. Tighten the screws firmly in place.

Step 9: Connect the wires to the loudspeaker. Set the rear panel switch to the desired option.

NOTE: DO NOT PLACE THE LOUDSPEAKER FACE DOWN.

AVOID TOUCHING THE TWEETER DOME.

Step 10: The loudspeaker can now be mounted onto the wall bracket. Slide the loudspeaker

onto the bracket from above, as shown. Make sure the brackets are firmly mated before releasing

the ºloudspeaker.

WALL STUD

WALL BRACKET

Harman Consumer Group, Inc., Northridge, CA USA © 2007 Harman International Industries, Incorporated.

All Rights Reserved P.N. # 362781-001

STUD

STUD

CEILING

15 1/2 inch MIN.

3 inch