Rimage DL5200 Reference Manual
Download Replacement of Rimage DL5200 Computer Hardware, Disc Duplicator for Free or View it Online on All-Guides.com.
Brand: Rimage
Category: Computer Hardware , Disc Duplicator , Printer
Type: Replacement
Model: Rimage DL5200 , Rimage DLN5200
Pages: 2 (0.31 Mb)
1
2
From the back of the autoloader, disconnect the cables:
Power Cord•
FireWire Cable•
USB Cable•
From the back of the autoloader, disconnect the cables:
Power Cord•
Serial Cable• , if present
Network Cable•
USB Cable•
Monitor•
Keyboard•
Mouse•
OR
2000712_B
Copyright © 2008 Rimage Corporation
USB Cable
Printer Power Cord
Printer Cable
Keyboard*
Mouse*
Monitor*
Serial Cable
Power Cord
Network Cable
USB Cable
Power Cord
FireWire Cable
USB Cable
Replace the Rimage DL/DLN5200
Before you begin:
1. Stop or pause all jobs.
2. Power off the embedded control center.
3. Power off the 5200.
4. Disconnect the power cord from the 5200.
b. Remove the printer from the 5200 and set it aside.
a. From the back of the printer disconnect the cables.
Caution: Some cables in your system may be latched. Equipment
damage may occur if cables are not disconnected appropriately.
Caution: Lift the Everest printer with care; it is very heavy.
*A monitor, keyboard, and mouse are required only if the system is not
connected to a network.
Remove the printer.
Disconnect the cables. (DL5200)
Disconnect the cables. (DLN5200)
Use this procedure to set up your replacement unit when you are completing a rapid
exchange.
The term ‘5200’ is used throughout this document to refer to the DL5200 and the
DLN5200.
✎ Note: Your system may not look exactly like the system pictured.
Printer Power Cord•
Printer Cable•
USB Cable•
2
2
1