SIIG CyberParallel PCI Installation Manual
Download Installation manual of SIIG CyberParallel Dual Computer Hardware, Network Card for Free or View it Online on All-Guides.com.
Brand: SIIG
Category: Computer Hardware , Network Card , PCI Card
Type: Installation manual for SIIG CyberParallel Dual
Pages: 8 (0.04 Mb)
1
2
3
4
5
6
7
8
2-1
Installation
Chapter 2
Installation
This chapter will guide you through the installation of your
CyberParallel PCI. There are no jumpers or switches to set for
this PCI Plug-n-Play board.
2-1 Installing the
CyberParallel PCI
Proceed with the following instructions to install the board in
your computer. General installation instructions are given
since the design of computer cases varies. Refer to your
computer’s reference manual whenever in doubt.
Note: Leave the CyberParallel PCI board in its
static-resistant bag until you are ready to install it.
1. Turn OFF the power to your computer and any other
connected peripheral devices. Follow the precautions for
static electricity discharge.
CAUTION: STATIC ELECTRICITY DISCHARGE
may permanently damage your system. In order to
avoid possible static electricity discharge during
installation procedures, please follow the guidelines
below:
• Discharge any static electricity build up in your body by
touching a large grounded metal surface such as the
computer case (if plugged in), a metal window frame,
refrigerator, or water tap for a few seconds.
• During installation procedures, avoid any contact with
internal parts. Handle cards only by their edges.
CAUTION: Disconnect the AC power source
before removing the cover.