RUSSOUND 862P PLASMA EYE Instruction Manual

Download Instruction manual of Russound 862P PLASMA EYE Other for Free or View it Online on All-Guides.com.

Brand: Russound

Category: Other

Type: Instruction manual for Russound 862P PLASMA EYE

Pages: 2 (0.74 Mb)

Download Russound 862P PLASMA EYE Instruction manual

Russound 862P PLASMA EYE Instruction manual - Page 1
1
Russound 862P PLASMA EYE Instruction manual - Page 2
2
PRODUCT OVERVIEW
The SaphIR 862P Plasma Eye receives IR signals from a handheld IR remote
control and relays these signals to the audio/video equipment for operation
from another room. Mounts through a circular hole with a diameter of 0.5”,
requires a minimum clearance of 2.0” behind the face of the mounting sur-
face, and will mount in a panel with a maximum thickness of 1.75”.
FEATURES
Plasma-friendly - can be placed near plasma TVs and displays.
CFL-friendly - allows installations in areas with compact fluorescent
lighting. Works in most lighting environments.
Comes with interchangeable white, black and brass bezels to easily
customize your installation.
Blue IR confirmation LED.
Can easily be mounted in many in-wall speakers (such as Russound
Advantage® and Atmosphere) and custom cabinets.
Wide band IR. Receives IR from many types of remotes.
BEZEL EXCHANGE
The SaphIR 862P Plasma Eye comes with three bezels (white, black, brass) for
more installation color choices.
To remove the bezel, hold the barrel steady and upright and twist the bezel
until it clears the top of the barrel. Make sure the small tinted plasma filter
stays in place at the end of the barrel.
To replace the bezel, center the bezel over the filter and barrel, thread onto
the barrel end and twist until snug.
Plasma Filter
Bezel
Nut
Barrel
Mounting
Surface
Front
Mounting
Surface
Rear
Washer
Max thickness
1.75”
Min. clearance
2.0”
SaphIR
862P Plasma Eye
Mini Infrared Receiver
Plasma and CFL Friendly
Instruction Manual
Panel
Face
INSTALLATION
The SaphIR 862P Plasma Eye is installed into a circular hole 0.5” in diameter.
Remove the nut from the receiver’s barrel. Insert the Eye (wire end first)
until the bezel is flush with the surface. Rethread the nut onto the barrel
until it is snug against the rear of the mounting surface. If necessary, use
one or both of the included washers for a more secure installation into soft
or thin materials.
CONNECT TO
846C OR 1201A
POWER
SUPPLY
EMITTER PORTS
857
CONNECTING
BLOCK
123456
IR R
ECEIVER
I
N
IR C
OMMON
I
N
IR C
ONFIRM
+
12VDC
GND
STATUS
SIGNAL
EMITTERS
S
TATUS
+
12VDC
P
OWER
+
12VDC
DESIGNED IN USA MADE IN CHINA
857 I
NFRARED
C
ONNECTING
B
LOCK
12 VDC
SIGNAL (White)
+12VDC (Black)
GND (Black)
WIRE CONNECTIONS
Direct Connection from 862P Plasma Eye to Connecting Block
Connect the SaphIR 862P Plasma Eye to the 857 or equivalent connecting
block. Connect GND (GROUND), IR (SIGNAL) and Voltage (+12VDC ) to con-
nector on the 857.