SkyLink MFV-310S User Manual

Download Operation & user’s manual of LG LDV-S503 DVR, Garage Door Opener for Free or View it Online on All-Guides.com. This version of LG LDV-S503 Manual compatible with such list of devices, as: LDV-S503, Wave SoundTouch, MFV-310S, TDP-T95, Wave SoundTouch

LG LDV-S503 Operation & user’s manual - Page 1
1
MODEL : MFV-310S
SKYLINK
®
GARAGE DOOR REMOTE
1. PROGRAMMING YOUR NEW TRANSMITTER FOR
STANLEY
®
OPENERS
Thank you for your purchase of the Skylink
®
garage door remote control,
Model MFV-310S. This remote is designed to work with Stanley
®
garage
door opener with DIP switches. Please follow the details instructions below
to setup the new transmitter to work with your existing opener.
1. Open the case with a coin.
2. For code setting:
Remove the battery cover on your Stanley
®
transmitter or the cover on
receiver located on your garage door opener. Match the DIP switches
on the Skylink
®
transmitter to already existing transmitter or receiver DIP
switches.
3. Test the transmitter by pressing onto the button (see figure), the
red LED should come on and it should activate the garage door.
Close the case firmly.
CUSTOMER SERVICE
17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3
http://www.skylinkhome.com
US Pat. 377458
P/N 101Z559
© 2008 SKYLINK GROUP
® are registered trademarks of their respective corporations
2. TROUBLESHOOTING
If the garage door cannot be activated, check the followings:
- Ensure the DIP switch setting on the Skylink
®
is identical to the existing
Stanley
®
remote.
- Ensure all the DIP switches are pushed either all the way to the top, or
bottom, not somewhere in the middle
- The red light LED should come on when the button is pressed, if not,
check the battery and its polarity, ensure it is inserted properly.
DO NOT let children use the garage door
transmitter without adult supervision.
Children can injure themselves or others
by the garage door.
5. WARNING
If this transmitter triggers other garage doors in your neighborhood,
change all your transmitters and receiver to a new code setting.
Dip Switch
8. CUSTOMER SERVICE
Skylink will not be held liable or responsible for any misuse or application of this
product other than for its intended use.
If you would like to order Skylink’s products or have difficulty getting them to work
or download latest information and user manual, please :
1. visit our FAQ section at www.skylinkhome.com, or
2. email us at [email protected], or
3. call our toll free at 1-800-304-1187 from Monday to Friday, 9 am to 5 pm EST.
Fax 1-800-286-1320
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
If, within one year from date of purchase, this product should become defective
(except battery), due to faulty workmanship or materials, it will be repaired or
replaced, without charge. Proof of purchase and a Return Authorization are required.
7. WARRANTY
6. FCC
Dip Switch
3. VISOR CLIP INSTALLATION
12 volt alkaline battery
(size 23A) included.
4. BATTERY
Button
Examples of how to set Skylink Transmitter
STANLEY 1050
SKYLINK Model MFV-310S