SMEG CP60X8 Manual
Download Manual of Smeg CP60X8 Computer Hardware for Free or View it Online on All-Guides.com.
Brand: Smeg
Category: Computer Hardware
Type: Manual
Model: Smeg CP60X8 , Smeg CP60X9 , Smeg GP61X8
Pages: 36 (4.32 Mb)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
70
Instructions for the installer
11.4 Electrical connection
Make sure the voltage and the cross-section of the power supply line match the specifications indicated
on the identification plate positioned on the appliance. Do not remove this plate for any reason. A copy of
the plate is attached to the instructions.
The appliance must be connected to the electric supply by a qualified technician.
Before performing any operations, switch off the power supply to the appliance.
The appliance must be connected to earth in compliance with electrical system safety regulations.
Where the appliance is connected to the power grid via a plug and socket, both of these must be of the
same type and connected to the power cable in accordance with the applicable regulations. The socket
must be accessible after the appliance has been built in. NEVER UNPLUG BY PULLING ON THE
CABLE.
In caso di sostituzione: Should the earthing wire need replacing, it must be longer than the current
conduction wires so that, if the plug is torn off the power cable, it is the last to be detached.
Avoid use of adapters and shunts as these could cause overheating and risk of burns.
If a fixed connection is being used, fit the power line with an omnipolar circuit breaker with a contact
opening gap equal to or greater than 3 mm, in an easily accessible position close to the appliance.
The manufacturer cannot be held liable for damage to persons or things caused by failure to observe
the above instructions or deriving from tampering with any part of the appliance.
APPLIANCE
TYPE
(CM)
POSSIBLE CONNECTION
TYPES
CABLE TYPE
(if not present)
60
220 - 240 V 1N~ 3-pole 3 x 1.5 mm² H05V2V2-F
appliance side
• Use H05V2V2-F cables resistant to at least 90 °C.
• The values indicated above refer to the cross-section of the internal conductor.
• The tightening torque of the screws of the terminal supply wires must be 1.5 - 2 Nm.
• The aforementioned power cables are sized taking into account the coincidence factor (in
compliance with standard EN 60335-2-6).