Smeg AS28I96L Instructions For Installation And Use Manual

Download Instructions for installation and use manual of Smeg AS28I96L Cooktop for Free or View it Online on All-Guides.com. This version of Smeg AS28I96L Manual compatible with such list of devices, as: PLAL24S, PLAL24S1N, PS19/1S, PVE128, PVNL128

Smeg AS28I96L Instructions for installation and use manual - Page 1
1
Smeg AS28I96L Instructions for installation and use manual - Page 2
2
Smeg AS28I96L Instructions for installation and use manual - Page 3
3
Smeg AS28I96L Instructions for installation and use manual - Page 4
4
Smeg AS28I96L Instructions for installation and use manual - Page 5
5
Smeg AS28I96L Instructions for installation and use manual - Page 6
6
Smeg AS28I96L Instructions for installation and use manual - Page 7
7
Smeg AS28I96L Instructions for installation and use manual - Page 8
8
Smeg AS28I96L Instructions for installation and use manual - Page 9
9
Smeg AS28I96L Instructions for installation and use manual - Page 10
10
Smeg AS28I96L Instructions for installation and use manual - Page 11
11
Smeg AS28I96L Instructions for installation and use manual - Page 12
12
Smeg AS28I96L Instructions for installation and use manual - Page 13
13
Smeg AS28I96L Instructions for installation and use manual - Page 14
14
Instructions for the user
29
5. USE OF THE COOKING HOB
5.1 Burner knob
To light the flame, press and turn the
knob anticlockwise to the large flame
symbol. Adjust the flame by turning the
knob to the area comprised between
maximum and minimum marks. To
turn off, set the knob to either or 0.
5.2 Lighting the burners
Before lighting the burners make sure that the flame cap crowns are
properly fitted into their seats and equipped with the corresponding caps,
and check that niche A is aligned with pin B.
Grid C (available in some models) is intended for use with “wok” pans.
Each knob corresponds to the burner indicated. The appliance is
equipped with an electronic lighting device. To light the burners, press
and turn the knob anticlockwise to the large flame symbol. Keep the
knob pressed for about 2 seconds to let the thermocouple heat up. If the
burner turns off when the knob is released, it means that the
thermocouple isn’t hot enough. Repeat ignition and keep the knob
pressed longer.
If the burners turn off accidentally, a safety device will trip after about 20
seconds to cut off gas flow (even with the gas tap open).