Gianni Industries Electromechanical Lock Installation Instructions

Download Installation instructions of Gianni Industries Electromechanical Lock Door for Free or View it Online on All-Guides.com.

Gianni Industries Electromechanical Lock Installation instructions - Page 1
1
Gianni Industries Electromechanical Lock Installation instructions - Page 2
2
Copyright © All Rights Reserved. P-MU-ML-300 Ver. H Publish: 2010.12.24
4-1
ML-300
ML-300-SW
Operating Voltage» ML-300: 12 or 24VDC
ML-300-SW: 12~24VDC/AC
Voltage Tolerance» ±10%
Current Draw» ML-300: 280mA/12VDC; 140mA/24VDC
ML-300-SW: 210mA/12VDC; 150mA/24VDC
Version Changeable» Fail-safe or Fail-secure
Operating Temperature» -10~45°C
Humidity» 0~95% non-condensing
Lock bolt sensor switch output» SPDT rated 3A/125VAC
Solenoid testing» Tested to 1,000,000! cycles
Net Weight» ML-300: 800g / ML-300-SW: 815g
Just applicable to vertical installation
Copyright © All Rights Reserved. P-MU-ML-300 Ver. H Publish: 2010.12.24
4-4
62mm cylinder for max 42mm door leaf
72mm cylinder for max 52mm door leaf
ø5.0
ø5.0
25
28
150
28
124
250
30
30
5 6 7 8
30
ø5.0
ø5.0
1 2 3 4
Electromechanical Lock
Installation Instruction
Specification Double Swing Doors
Double swing door Outswing Inswing
Version Changeable:
Take out the Screw 1 , release screw 2 , move the
position and then tighten both screws.
“Fail-Safe”
(Power to Lock)
“Fail-Secure”
(Power to Open)
Caution:
Fixing Lug
Allen wrench (1.6mm)
NIB
Lock bolt
Strike Plate
For double swing door
For single swing door
Euro profile
key cylinder
Unit:mm
Installation Instructions
D
o
or leaf
D
oo
r Frame
Door Loop
(Optional)
(
C
y
li
n
d
e
r
n
o
t
i
nc
l
u
d
ed
)
Align the center line (CL) of the
Alignment CL
F
r
a
m
e
D
o
o
r
L
e
a
f
D
o
o
r
L
e
a
f
Cut out mortise holes for the lock
Tighten the fixing lugs with
screws.
Drill and cut the hole for the lock
Connect power cable to the lock
Attach the cover plates for the
Install the cylinder
Fix the strike plate.
Stud bolt Position
Packing Contents
Do not completely remove screw 2 (as marked in the figure)
as the interior solenoid might fall off.
The door loop protects the wiring
from damage at the door hinge.
Attention! Please ensure that the
direction of the template is correct
D
o
o
r
F
r
am
e
lock body template with the CL of
the door leaf. Ensure the CL of the
strike plate template matches the lock
body CL as closely as possible.
body and strike plate and drill holes
according to the templates.
cylinders as shown in the template.
and test before screwing to the
door leaf.
cylinder lock
For fail-safe mode
For fail-secure mode