Smeg ML60 Instruction Manual
Download Instruction manual of Smeg ML60 Indoor Furnishing for Free or View it Online on All-Guides.com.
1
2
3
4
5
6
7
8
9
10
11
12
22
Instructions for the installer
4. WATER DRAIN
The water drainage can be connected up in three different ways
depending on requirements and the location of the sink.
The drain can be connected:
• to a tank-type container
• for dispersion into the environment
• to the network.
4.1 To a tank
In this case, a quick coupler joint is required for the drain.
A tube with a suitable diameter should then be connected up and
inserted into the coupler, locking it with a clamp or similar part.
Check the water level inside the tank and empty it if it is full.
PLEASE NOTE!
To ensure that the tube does not detach accidentally and spill
water into the surrounding area, make sure that it is securely
attached to the drain connector.
Similarly, check that the tube is inserted properly into the tank.
4.2 For dispersion away from the sink
The connection is the same time as the one used for the tank.
It is important to establish in advance where you wish to direct the
drainage water.
Connect a tube long enough to convey the water to the intended
discharge point.
You are advised to discharge the water to a drain well which is
connected to the sewage system.
4.3 To the network
For connection to the water distribution network see SECTION 4 -
CONNECTION TO THE WATER DISTRIBUTION NETWORK