Smeg CSA19ID-6 Owner's Manual

Download Owner's manual of Smeg CSA19 Microwave Oven for Free or View it Online on All-Guides.com. This version of Smeg CSA19 Manual compatible with such list of devices, as: CSA19, CSA196, CSA196A, CSA196XLP, CSA20

Smeg CSA19 Owner's manual - Page 1
1
Smeg CSA19 Owner's manual - Page 2
2
Smeg CSA19 Owner's manual - Page 3
3
Smeg CSA19 Owner's manual - Page 4
4
Smeg CSA19 Owner's manual - Page 5
5
Smeg CSA19 Owner's manual - Page 6
6
Smeg CSA19 Owner's manual - Page 7
7
Smeg CSA19 Owner's manual - Page 8
8
Smeg CSA19 Owner's manual - Page 9
9
Smeg CSA19 Owner's manual - Page 10
10
Smeg CSA19 Owner's manual - Page 11
11
Smeg CSA19 Owner's manual - Page 12
12
Smeg CSA19 Owner's manual - Page 13
13
Smeg CSA19 Owner's manual - Page 14
14
Smeg CSA19 Owner's manual - Page 15
15
Smeg CSA19 Owner's manual - Page 16
16
Smeg CSA19 Owner's manual - Page 17
17
Smeg CSA19 Owner's manual - Page 18
18
Smeg CSA19 Owner's manual - Page 19
19
Smeg CSA19 Owner's manual - Page 20
20
Smeg CSA19 Owner's manual - Page 21
21
Smeg CSA19 Owner's manual - Page 22
22
Smeg CSA19 Owner's manual - Page 23
23
Smeg CSA19 Owner's manual - Page 24
24
Smeg CSA19 Owner's manual - Page 25
25
Smeg CSA19 Owner's manual - Page 26
26
Smeg CSA19 Owner's manual - Page 27
27
Smeg CSA19 Owner's manual - Page 28
28
Smeg CSA19 Owner's manual - Page 29
29
Smeg CSA19 Owner's manual - Page 30
30
Smeg CSA19 Owner's manual - Page 31
31
Smeg CSA19 Owner's manual - Page 32
32
Instructions for the installer
3. ADAPTATION TO DIFFERENT TYPES OF GAS
Before performing any cleaning or maintenance work, detach the
appliance from the electrical socket.
The hob of the cooker is adjusted for use with natural gas at a pressure of
1.0kPa. If used with other types of gas, you have to replace the nozzles and
regulate the primary air to the burners. Then adjust the minimum flame on the
gas taps. For nozzle replacement and burner adjustment you must raise the
hob as described in the following paragraph.
3.1 Raising of the hob
Remove the grids, first the middle one then the ones at the sides; remove all
the burner caps, the flame cap crowns and the burners.
1. Remove the programmer buttons;
2. Remove the knobs;
3. Unscrew the front panel fixing screws and remove it after disconnecting
the thermostat tell-tale light faston;
4. Loosen the screws of the hinge on the back of the cooker;
5. Raise the surface from the front end;
6. Place the surface support brackets in the front groove of the side;
7. Proceed to replacement of the burner nozzles in accordance with the
appropriate gas table;
8. Adjust the primary air as described in paragraph “3.2
Adjustment for
LPG
”;
9. After adjustment, fully tighten the fixing screws.
11