Smeg ABM30 Instructions For Installation And Use Manual

Download Instructions for installation and use manual of Smeg ABM30 Refrigerator for Free or View it Online on All-Guides.com.

Brand: Smeg

Type: Instructions for installation and use manual

Pages: 9 (0.89 Mb)

Instructions for the Installer

4.2 Fully Built-In Version

Minibars can easily be built into any suitable cabinet. It is essential to comply with the following

guidelines:

1 Make sure that sufficient ventilation can reach the refrigeration unit, on the rear of the minibar.

2 Sketches A, B and C (fig. 2) show various alternatives for building-in your minibar;

3 The ventilation gaps, for both incoming and outgoing air, must measure at least 200 cm

and it is

indispensable to take care that any ventilation grilles cannot be obstructed in any way.

All minibar models are equipped:

- with two adjustable-height feet;

- with two fixing plates in the base;

- with a door with linkage fixtures for opening and closing, which connect the door of the appliance to

the door of the cabinet in which it is to be built-in.

The minibar is delivered with the door hinged on the right-hand side.

If you wish to open it in the other direction, simply move the hinges to the other side, where fixing holes

are provided on the top and bottom, and swap them around. The top right-hand hinge will be fitted at

bottom left, and vice-versa. To fit the top hinge, remove the cap over the hole provided and reuse it to

plug the hole in the original hinge fitting position.

Place the minibar inside the cabinet, centring it so that any gaps are the same on both sides.

Move it backwards or forwards so that the gap between the cabinet and appliance doors does not

exceed 5-6 mm (Fig. 3)

2) 3)

To fix the bracket which links the appliance door to the door of the cabinet, proceed as follows.

Make two holes to which the bracket will then be fixed, referring to the

measurements shown in figure 4.

Top Brands