SMEG SE2664TCX Instructions Manual
Download Instructions for fitting and use of Smeg SE2664TCX Touch Panel for Free or View it Online on All-Guides.com.
Brand: Smeg
Category: Touch Panel
Type: Instructions for fitting and use for Smeg SE2664TCX
Pages: 11 (0.34 Mb)
1
2
3
4
5
6
7
8
9
10
11
224811 29
4.3 Electrical connections (connected loads)
(Connected loads and model designation: see front of the operating instructions)
This appliance may only be connected to the electricity supply by an approved electrician who must ensure that
the installation complies with the statutory regulations (Germany VDE, Austria ÖVE, Switzerland SEV, etc.). The
electrician must ensure that these regulations and those laid down by the local electricity supply company are
observed.
When connecting the electrical appliance, install an all-pole disconnecting device with a contact gap of at least
3 mm. Make sure that the local mains voltage is the same as the voltage on the rating label.
To connect the appliance, unscrew the switchbox cover on the underside of the appliance to access the terminal
block. After connecting the appliance, replace the cover and secure the connection cable with the strain relief
clamp.
The connection cable must be at least H05 VVF.
If the excess cable of this appliance is damaged, it has to be replaced by the manufacturer, the Customer
service of the manufacturer or by another qualified person to avoid danger.
Make sure that the excess cable length is not laid in the hob’s installation area. See fig. 4 for the position
of the cable cut-out.
Ensure that all live connections are safely insulated when installing the oven.
Electrical connections
4.4 Service work
Always disconnect the appliance from the mains before carrying out repairs, this means the cut-out device must
be opened. If you have to contact our service department, always quote the type and make numbers. You can find
these numbers on the rating label or on page 1 of the Operating Instructions. Each time the glass ceramic hob is
removed from the worktop, check the seals and replace if necessary.